2. TRANSGO
  3. 48-CCV 4L80E
48-CCV 4L80E

TRANSGO 48-CCV 4L80E, 48-CCV 4L80E, TCC Conversion Valve User manual

  • Hello! I've reviewed the provided instructions for the TRANSGO 48-CCV 4L80E Converter Conversion Kit. This kit is designed for non-lockup converters, addressing issues with converter fill and lube flow. I'm here to answer your questions about its components and installation steps.
  • What type of converter is this kit designed for?
    What does this kit correct?
    What is included in this kit?
    What problem does this kit prevent?
48-CCV
4L80E Converter
Conversion Kit
Important: This kit cannot be used with a
computer that allows lockup. This kit corrects
converter fill and lube flow, for performance
when using a non-lockup converter. It can not
be used with a converter that has a lock-up
plate!
Grind off Stem
TCC Enable Valve
Re-Use
Roll-Pin
Step 4
Converter Limit Valve
New
Red Step 1
Install new RED inner spring on Converter
Limit Valve. Then Re-install original spring,
end plug and retainer.
Re-Use
Step 2
Grind the the stem off the long stem end
of the TCC enable valve. Re-install the
original spring and then the end of the
valve that was ground off.
Step 3
Discard the original lock-up valve and
spring. Install New valve and original
end plug and retainer.
Re-Use
New Valve. Install the plugs furnished,
just below flush, into these
two holes.
New
Plugs
Note: This kit has the flow and
pressure necessary to keep the
converter full under heavy load or
high HP use.
Without this kit, the converter will
tend to empty of fluid under high
load conditions.
© TransGo 2011
29 Aug 2011
/