Brodit 854788 Datasheet

Category
Holders
Type
Datasheet
28 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854788
854788 ProClip
Angled mount, ONLY for the Wing Dash style.
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288547886
Item no 854788 fits:
Freightliner Business Class M2 09-15 (For USA)
Freightliner Severe Duty 108SD 12-15 (For USA)
Freightliner Severe Duty 114SD 12-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Remove the screw above
the air vent. Peel off the cover of adhesive tape on the ProClip. Use your left hand to pull the top part of the panel
frame towards approx. 15 mm (1/2 inch). Hook the angled edge on the right side of the ProClip around the panel
frame edge.
2. Align the ProClip over the screw hole. Push the panel frame back into place and screw the screw just a few
threads into the screw hole.
3. Using your left hand again, pull the panel frame slightly towards you. Push forward on the left side of the
ProClip so the angled edge hooks around the panel frame edge. Push the panel frame back into place and
secure it and the ProClip by tightening the screw.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 854788 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI