28 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 854762
854762 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288547626
Item no 854762 fits:
Freightliner Cascadia 08-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pcitures before attaching the ProClip. This ProClip consists of
two parts: Part 1: The small block with curved lip. Part 2: The ProClip faceplate
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Loosen (do not remove)
the two right side torx screws on the control panel. Press the thin end of the enclosed gap opener into the gap in
the center console sidewall, to widen the gap. Start at the far right side of the gap and slide it leftward into the
correct position.
2. Peel off the cover of adhesive tape on both parts. Insert the curved edge of Part 1 into the gap next to the gap
opener. Flip/rotate Part 1 upward so the curved edge goes into the gap. Before adhering it to the dash please
make sure the holes will line up with Part 2.
3. Pull the panel towards you in order to widen the gap. Press the curved edge of Part 2 into the panel gap.
Flip/rotate the right side of the ProClip toward Part 1. Match the holes on the right side of Part 2 with the holes on
Part 1 using the lines on top of Part 1 for guidance. Use the enclosed screws to attach Part 2 to Part 1. Draw the
screws tight but be careful not to over tighten. Tighten the 2 torx screws in the control panel.
4. The ProClip is in place.
2(2)
/