Lenoxx CD-155 Operation Instructions

Brand: Lenoxx

Model: CD-155

Category: CD players

Type: Operation Instructions

TTTT

ACHING THE SPEAKERSACHING THE SPEAKERS

ACHING THE SPEAKERS

NOTE:NOTE:

NOTE: The right and left speakers are

NOTNOT

NOT

interchangeable. The right speaker

fits only on the right side (as shown

in FIG. 1). The left speaker fits only

on the left side.

1.Bring the right speaker to the right side

of the set.

2.Raise the right speaker box about 1 inch

higher than set. Align the tracks (rails).

3.Fit speaker over the side rails.

4.When speaker fits over the rails, lower

the speaker as shown in FIG. 2, and make

sure the locks snap into the speaker box.

5.Repeat above steps 1 to 4 for the left

speaker box.

6.Carefully unwind the speaker wire from behind each speaker box and plug the right

plug into Speaker Jack R also plug the left plug into Speaker Jack L (as shown in

FIG. 3). Wrap the remaining wire behind each speaker box.

NOTE:NOTE:

NOTE: This set can be used with speaker boxes attached to the cabinet or

separated, just make sure both speaker plugs are plugged into the jacks.

FIG. 1

FIG.2

FIG. 3

SPEAKER

CD-155S112598

E V.1

O PLAO PLA

O PLA

THE RADIO THE RADIO

THE RADIO

Make sure the speakers are connected (plugged into the jacks in the back).

1. Slide the Function Switch to RADIO (the Power Lamp will light).

2. Select required wave band (AM, FM or FM STEREO) with Band Switch.

3. Tune to required station with the Tuning Control.

4. Gently rock this control back and forth until you get the strongest, clearest sound.

5. The built-in AM antenna and the FM rod antenna are directional. When receiving FM

broadcasts, carefully extend the FM Telescoping Antenna to its full length. The

strongest reception can be achieved by rotating the set or the FM Antenna.

6. Adjust the Volume Control to your listening preference.

7. If you prefer more bass, slide the Bass Boost Switch to ON.

8. To turn off the radio, slide the Function Switch to TAPE position (RADIO OFF), the

Power Lamp will go off.

NOTE:NOTE:

NOTE: FM Stereo is weaker than FM (mono). If your FM stereo station is weak or

you hear too much noise or hissing, try to adjust the FM Telescoping Antenna

or slide the Band Switch from FM STEREO to FM.

BASS BOOST SWITCHBASS BOOST SWITCH

BASS BOOST SWITCH

This set has a Bass Boost Switch which allows you to hear more bass (low frequency)

sounds. You may slide this ON or OFF to your taste.

STEREO HEADPHONE JACKSTEREO HEADPHONE JACK

STEREO HEADPHONE JACK

A Stereo Headphone Jack has been provided on the front of the set so that you can

listen to the set without disturbing others. To use this jack, plug in low impedance

stereo headphones (not included) and adjust the Volume Control to your taste. Special

internal switches will turn off the sets speakers when you plug in the stereo headphones.

BASS BOOST

ON OFF

OPTIONAL STEREO

HEADPHONES

(8 Ohms or similar)

3.5 mm

(mini stereo plug)

CD-155S112598

E V.1

5. The Display will show 2 zeros   and then the total number of

tracks (songs)on the CD.

6. To start the music, press the CD Play/Pause Button (wait a few seconds for music

to start). The first track number   will appear in the Display, the Play/Prog.

Indicator will light and the disc will start playing.

7. Adjust the Volume Control to your taste. For extra bass sound, slide the Bass

Boost Switch to ON.

CD OPERACD OPERA

CD OPERA

TIONTION

TION

Bear in mind the following points, since any dirt, scratches

or warping of the disc can cause broken or intermittent sound

and also noise.





When holding the discs, take care not to touch the playing

surface.





Store the discs in their cases. Return them to their cases

with the label surface facing up and push down lightly on

the label surface.





Do not place discs near a heating device or a place where

the temperature is high or in dusty areas.





Do not write on the label surface using a ballpoint pen and

do no stick labels on the CD.





Wipe away any fingerprints or dust on the playing surface

of a disc using a soft cloth.

Bear in mind the following points when cleaning your discs:

- Always wipe from the inside toward the outside of the disc.

- Never in a circular motion.

- Do not use conventional record cleaners, anti-static agents,

benzene, thinner or other solvents.

PLAPLA

PLA

YING AYING A

YING A

CD - COMP CD - COMP

CD - COMP

ACTACT

ACT

DISC DISC

DISC

1. Slide the Function Switch to the CD position, the Power Lamp will light and the

Display will show 2 zeros  .

2. Press the Open Button (near the door) to open the CD door.

3. Insert a CD with the

LABELLABEL

LABEL side facing

UPUP

UP (If the disc is upside down, the Display

will show 2 zeros   and then  ).

4. Close the CD Door by pushing the Door down with your finger on the right side

marked CLOSE.

CD-155S112598

E V.1

HANDLE DISC AS SHOWN

CLEAN FROM CENTER TO EDGE

HANDLING A DISCHANDLING A DISC

HANDLING A DISC

Although built to withstand a certain amount of the effects from dust, soil and scratches,

discs should be treated with the care normally accorded to conventional analog discs

(records). Always protect a disc against scratches, soil and dust etc. We recommend

that during non-use periods, the discs should be stored in their original cases.

8. To pause the music - if the phone rings or other reasons, press the

Play/Pause Button, the track number will flash to remind you that you

are in pause mode.

9. To resume the music from pause, press the Play/Pause Button again. The track

number will be steady on (not flashing).

10. To stop playing music, press the CD Stop Button.

11. To turn off the CD, slide the Function Switch to TAPE (POWER OFF) position, the

Power Lamp will go off.

Total tracks

Track number

flashing

CD OPERACD OPERA

CD OPERA

TIONTION

TION

REMOVING A DISCREMOVING A DISC

REMOVING A DISC

1. Make sure the CD is not playing. If it is, press the CD Stop Button.

2. Press the Open Button to open the CD Door.

3. Gently remove the disc.

4. Close the CD Door by hand.

5. Replace the disc in its original case.

NOTENOTE

NOTE: Never press the CD Door down during play, this may cause malfunction or

damage to the disc. Always stop the CD player by using the CD Stop Button

before you take the disc out of the compartment.

NOTE:NOTE:

NOTE: If you hit or move the CD during play, the music will stop for a second or two

and then start again. This is normal operation for all portable CD players.

SKIPPING TRACKS (SKIP)SKIPPING TRACKS (SKIP)

SKIPPING TRACKS (SKIP)

1. This function enables you to find the beginning of any desired track during play. If the

CD Forward Search/Skip ( ) Button is pressed once or repeatedly, the

NEXTNEXT

TRACKTRACK

TRACK or one of the following tracks will be selected. The Display will show the

track or song number.

2. If the CD Back Search/Skip ( ) Button is pressed twice or more in rapid

succession, play will go

BACKBACK

BACK one track per press.

3. When the set is in the pause mode, it is also possible to select the beginning of a

certain track by using the CD Forward Search/Skip ( ) Button and CD Back

Search/Skip ( ) Button to reach the desired track. After selection, press Play.

4. Press and

HOLDHOLD

HOLD the CD Forward Search/Skip ( ) Button to search forward at a

high speed for a particular point of a song. Press and

HOLDHOLD

HOLD the CD Back Search/

Skip ( ) Button to search backward. Release the button to resume normal play

when the point is found.

REPEAREPEA

REPEA

PLA PLA

PLA

- SINGLE SONG - SINGLE SONG

- SINGLE SONG

To repeat the

SAMESAME

SAME song over and over again, do the following:

REPEAREPEA

REPEA

PLA PLA

PLA

- ALL - ALL

- ALL

SONGS SONGS

SONGS

To repeat play

ALLALL

ALL

SONGS SONGS

SONGS on a disc and then play them again and again, do the

following for non stop music.

1. When the CD is playing, press Repeat/Prog.

button twice.

2. The Repeat Lamp will be flashing.

CD-155S112598

E V.1

1. When the CD is stopped, press the Search/Skip Button to select the song you like.

2. Press the Play Button and the Repeat Button.

3. The Repeat Lamp will be steady on.

The song you selected will play over and over, till you

press Stop.

4. To stop the repeat function, press Repeat/Prog.

Button twice.

All the songs on the CD will play in order and then start all over again. To stop the

repeat function, press Repeat Button once.

COMPACT

DISC

DISPLAY

Repeat Lamp On

PLAY/PROG.

REPEAT

COMPACT

DISC

DISPLAY

Repeat Lamp flashing

PLAY/PROG.

REPEAT

RANDOM PLARANDOM PLA

RANDOM PLA

1. Press Random Button either in stop mode or normal play mode, the set will play all

of the songs in random order. The dispaly will show some moving symbols like

 ... ...  every 5 seconds.

2. Press the Forward Search/Skip Button to skip to the next random song.

3. To resume normal play, press Random Button again.

CD OPERACD OPERA

CD OPERA

TIONTION

TION

PROGRAMMED MEMORPROGRAMMED MEMOR

PROGRAMMED MEMOR

PLA PLA

PLA

Up to 16 tracks can be programmed for disc play in the order you like. Programming

can only be done during stop mode.

NOTE:NOTE:

NOTE: Under some conditions you may be able to program more than 16 tracks.

PROGRAMMED (MEMORPROGRAMMED (MEMOR

PROGRAMMED (MEMOR

Y) PLAY) PLA

Y) PLA

YBACKYBACK

YBACK

1. Press Repeat/Prog. Button when CD has

stopped.

2. The Display will show   and the Play/Prog.

Lamp will flash.

3. Press the Search/Skip Buttons either or

until the desired track shows on the Display.

The Play/Prog. Lamp will flash.

4. Press the Repeat/Prog. Button. The Display will

show   and the Play/Prog. Lamp will flash.

5. Repeat steps 3 and 4 until all the desired tracks are

programmed.

6. When you finished programming, press the

Play/Pause Button.

7. The Display will show the track number being

played, and the Play/Prog. Lamp will remain

flashing during programmed play.

8. All songs will play in the order you programmed.

9. If in middle of play, you want to hear the next

programmed song, press Search .

10. When all the songs have finished playing, the set will

stop. The Play/Prog. Lamp turns off.

11. To turn off the power, remember to slide the Function

Switch to TAPE (POWER OFF) position.

NOTENOTE

NOTE: Programming can only be done when the CD

is in the stop mode.

EXAMPLE: TEXAMPLE: T

EXAMPLE: T

o program track 4 to play first.o program track 4 to play first.

o program track 4 to play first.

When CD has stopped,





Press Repeat/Prog., will show and Play/Prog. Lamp will flash.





Press Search/Skip Button till track 4 appears.





The Display will show and Play/Prog. Lamp will flash.





Press Repeat/Prog., will show and Play/Prog. Lamp will flash.





Press Play.





Track 4 will play first.

NOTE:NOTE:

NOTE: The programmed memory will be cleared if CD door is opened or power is

turned off.

CD-155S112598

E V.1

PLAY/PROG.

Lenoxx CD-155 Operation Instructions

Brand: Lenoxx

Model: CD-155

Category: CD players

Type: Operation Instructions

Download PDF

report

in other languages

dansk: Lenoxx CD-155

Lenoxx CD-155 Operation Instructions

Lenoxx CD-155 Operation Instructions

in other languages

Related papers

Other documents