GearLight S1000 Operating instructions

Brand
GearLight
Model
S1000
Category
Flashlights
Type
Operating instructions
S1000 LED TACTICAL LANTERN FLASHLIGHT
Operation Guide
TROUBLESHOOTING
If the flashlight does not turn on, or works intermittently:
Replace the batteries.
Make sure the tail cap is twisted on tightly and batteries are inserted correctly.
If the flashlight flickers or changes modes automatically:
Make sure the tail cap is twisted on tightly.
If the light appears dim or faded:
Irvine, California | USA | www.GearLight.com
WARRANTY AND LIMITATION OF LIABILITY
MAINTENANCE
Inspect the flashlight monthly and carefully remove any damaged batteries and clean
any corrosion. If the flashlight is used less than once a month, remove the batteries
between uses. Lubricate all threads and rubber O-rings with petroleum jelly twice
yearly.
Limited One-Year Warranty
GearLight warrants this product for one year from the date of purchase
against any defects in material or workmanship. This warranty does not cover
normal wear and tear, nor damage resulting from misuse or neglect. We will,
at our discretion, repair, replace, or refund the purchase price of this product
should we determine it to be defective.
Limitation Of Liability
Liability limited to the purchase price of this product. GearLight shall not be
liable for any incidental or consequential damages or any implied warranty on
this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
If the problem persists, possible LED Failure. Contact GearLight for a replacement.
Replace the batteries.
1x GearLight S1000 LED Tactical Lantern Flashlight
1x 18650 Battery Tube
1x AAA Battery Holder (Inside Flashlight)
3x AAA Batteries
1x Lanyard
1x Operation Guide
1x Warranty Card
Package Contents:
IMPORTANT SAFETY NOTICE: Lithium-ion batteries are potentially hazardous and can present a
fire, explosion, and burn hazard. By using lithium-ion batteries, you agree that GearLight shall not
be liable for any incidental or consequential damages arising from, relating to or connected with the
use of lithium-ion batteries. If you do not agree with these conditions, please use only alkaline or
NiMH rechargeable batteries.
FOR YOUR SAFETY, READ BEFORE OPERATING
V2
WARNING: To avoid eye injury, do not stare directly into the light beam or shine the beam directly into
anyone’s eyes. Keep magnet away from children and magnetic-sensitive medical devices. Do not
attach the flashlight where it is directly above any person. It may fall and cause serious injuries.
CAUTION: The flashlight may become warm or hot after extended periods of use
at the highest setting. Select a lower setting when the flashlight is hot. This is
typical for high-powered flashlights and does not cause damage to the flashlight.
WARNING: Lithium-ion batteries can present a fire, explosion, and burn hazard. Use
only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo, Sony,
Samsung, or LG. Remove the battery when the flashlight is not in use. The use of
other cell manufacturers or the failure to follow the battery manufacturer's safety
instructions may result in fire, explosion, personal injury, and damage to property.
WARNING: Batteries can explode or leak and cause injury if installed backwards,
disassembled, charged, crushed, mixed with used or other battery types, or
exposed to fire or extreme temperatures. Replace all batteries at the same time.
AAA Battery Installation
1. Unfasten tail cap and remove battery holder.
2. Insert 3 AAA batteries following the correct polarity (+,-)
marked on the battery holder.
3. Insert the battery holder back into the
flashlight with the positive (+) end first.
On/O
Zoom (This function only works while on the “High” or “Medium” modes.)
1. Hold both ends of the flashlight; gently twist and pull each end away from the
other.
2. Pull the two ends away from each other to zoom in and push the two ends
together to zoom out.
To turn the flashlight on, press down firmly on the red power button located
on the tail of the flashlight until you hear a click.
To turn the flashlight o, press down firmly again until you hear a click.
18650 Lithium-ion Rechargeable Battery Installation (See Warning)
1. Insert one 18650 battery inside the 18650 clear battery tube.
2. Insert the combined 18650 battery and clear tube into the flashlight with the
positive (+) end first.
Switching Modes
There are 4 dierent lighting modes. (High, Medium, White Work Light, Red
Work Light)
To access COB work light, slide both ends of the flashlight away from each
other to reveal work light.
To switch through the dierent lighting modes, gently press down on the red
power button to alternate through the 4 modes.
GETTING STARTED
OPERATION
ZOOMABLE
DESIGN
RUBBER
O-RING
AAA
BATTERY
HOLDER
TAIL CAP
MAGNET
COB WORK
LIGHT
Slide
POWER
BUTTON
NOTE: The flashlight will start at the highest setting after being o for more
than 30 seconds.
  • Page 1 1
  • Page 2 2

GearLight S1000 Operating instructions

Brand
GearLight
Model
S1000
Category
Flashlights
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents