2. FLEXCO
  3. Aluminum MBRT6 & MBRT10 Clamp Bar

FLEXCO Aluminum MBRT6 & MBRT10 Clamp Bar Operating instructions

  • Hello! I'm your chat assistant. I've reviewed the user manual for retrofitting FLEXCO MBRT6 and MBRT10 Clamp Bars with a cambered clamp bar. This document provides detailed instructions on how to install the new clamp bar, focusing on the use of locator blocks and screws with loctite. I’m ready to answer your questions about this process, ensuring you have a clear understanding of the steps involved.
  • What is the initial step for retrofitting a cambered clamp bar?
    What tool is needed to loosen the locator block screws?
    What should be done with the old screws?
    What should be applied to the new screws?
2525 Wisconsin Avenue • Downers Grove, IL 60515-4200 U.S.A.
Tel: 1-630-971-0150 • Fax: 1-630-971-1180 • E-mail: info@exco.com
Visit www.flexco.com for other Flexco locations and products.
©2010 Flexible Steel Lacing Company. 12-13. For Reorder: X2230
Retrofit Aluminum MBRT6 & MBRT10 Clamp Bar
with Cambered Clamp Bar
1. In order to retrot a cambered clamp
bar, you need two locator blocks stacked
on top of each other. Check locator block
at each end of the tool. If you already have
two locator blocks – total height will be
approximately 3/4” (19 mm) – stacked at
each location, you do not need to continue.
Tools shipped prior to 2010 have only one
locator block.
2. Loosen and remove locator block screws
with the included 5/32” allen wrench.
Discard screws.
3. Place new locator block on top of
existing locator block. Total height will
be approximately 3/4” (19 mm). Align
screw holes.
4. Apply loctite (included) to new locator
block screws (included).
5. Place Screws into locator block. Use
allen wrench to tighten screws.
6. Repeat for other end of the tool.
X2230
/