2. HySecurity
  3. SwingSmart CNX Top Cap Shield

HySecurity SwingSmart CNX Top Cap Shield Installation guide

  • Hello! I've reviewed the provided instructions for the HySecurity SwingSmart CNX Top Cap Shield. This document details the process of installing the shield to protect the operator from external elements and prevent electrical hazards. I'm ready to assist with any questions you might have about the installation process or features of the shield.
  • What can happen if the top cap shield is not attached?
    What should I do with electrical components when they are wet?
    How should I secure the top cap shield?
D1043 REV. A ©2020 SWINGSMART CNX 20 www.hysecurity.com 1
Zip Tie Channels
in the Bottom of the
Top Cap Shield
Figure 1. Zip Tie Channels
Figure 2. Position the Top Cap Shield
Figure 3. Wrap the Zip Ties Around the Arm
NOTICE
Failure to attach the top cap shield can allow
water, dirt, sand, rodents, etc. to enter the
operator and negatively aect operator function
or cause failure.
1. Position the top cap shield underneath the operator
arm.
2. Thread zip ties through slots in shield. (Figure 1)
3. Secure shield to underside of operator arm with zip
ties. (Figure 2)
4. Trim the ends of the zip ties.
5. Slide the top cap shield against the opening in the
back cover and then pull it away less than 1/8 inch.
(Figure 3)
6. Center the top cap over the taper clamp and operator
arm. (Figure 4)
7. Lock the top cap in place with the key. (Figure 5)
SWINGSMART CNX TOP CAP SHIELD INSTRUCTIONS
WARNING
Risk of electric shock. Do not handle electrical
components when they are wet and energized.
Figure 4. Center the Top Cap
Figure 5. Lock the Top Cap In Place
/