HySecurity SwingRiser Bearing Shim Kit Installation guide

Installation Instructions: MX002057 Shim Kit

Shimming the Bearings

Cut-away view of SwingRiser post

Inner tube

Lower bearing

Outer square post

Bearing cap screws

Technical Support

Weld seam Hinge

¼ - 20

tapped

holes

One

inch

cutout

(25mm)

Standard 0.060-inch (2mm) Shim

Standard square post without inner tube

manufactured from 2/2008 to present.

Add shims to

worn bearing

and close gap

around inner

Maintain a consistent

gap of 0.020 to 0.040 inches (0.5 to 1.0mm)

around the diameter of the inner tube.

A B

¾-inch (19mm)