2. Computers & electronics
  3. Networking
  4. Cable network testers
  5. Hubbell Wiring Device-Kellems
  6. pd2502

Hubbell Wiring Device-Kellems pd2502 Installation guide

  • Hello! I'm an AI assistant trained to help you understand the provided document, which contains instructions for verifying wiring on Hubbell SnapConnect Receptacle Terminals using a common voltmeter. I've read through the document and can answer your questions about the testing procedures and interpreting the results, such as correct and incorrect wiring scenarios.
  • Can I perform the test with the circuit energized?
    Do I need to remove the protective polybag to conduct the test?
    What should I do if I get 0V readings?
Hubbell SnapConnect TM Receptacle Terminals
Instructions for Checking Correct Wiring
Supplementary Instruction Sheet for Reference by Technical Services Department. Provided Upon Request.
GENERAL INFORMATION
CAUTION: RISK OF ELECTRIC SHOCK.
The following test procedure is conducted when the circuit is energized.
NOTICE: To be conducted by a qualified person in accordance with national and local electrical codes.
WIRING INFORMATION
The correct wiring of an installed terminal can be verified with a common voltmeter using the test method below. The test
can be performed without removing the protective polybag by inserting the tester probes through the opening in the bag.
Lightly insert voltage meter probes into appropriate holes on face of terminal connector to just touch the contacts.
Observe the voltage readings as shown below. DO NOT force probe into the contacts or the contacts may be damaged.
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
Shelton, CT 06484
1-800-288-6000
www.hubbell-wiring.com
PD2502 (Page 1) 11/2011
H N G
1
2
= 120V
= 120V
Correct Wiring
1
2
= 120V
= 0V
NOT Correct Wiring H N G
3
3
3
= 120V
= 0V
REVERSED Hot and Neutral
OPEN Ground
1
2
= 0V
= 120V
NOT Correct Wiring H N G
3
3
3
= 120V
= 0V
REVERSED Hot and Ground
OPEN Neutral
1
2
= 0V
= 0V
NOT Correct Wiring
MEASURE VOLTAGE
Between Hot and Neutral &
Between Hot and Ground
2
1
2
1
Black White Green
OPEN Hot or
Combination of Reversed and
Open connections
Verify Hubbell SnapConnect TM Wiring
Using a Common Volt Meter
IF
IF
IF
IF
Black White Green
Black White Green
/