Product Instructions

Manual Valves

General Repair Instructions K-B-3MV8, K-B-4MV8

DISASSEMBLY

1) Secure the Valve Body onto a table top

2) Unthread the Lever from the Rotor and set it aside.

3) Using snap ring pliers, carefully remove and discard the Retaining Ring (use extreme caution, contents are

pressurized with spring force).

2) Place the new Springs into the internal holes of the Valve Body.

3) Lightly lubricate the new O-Rings with applicable lubrication and install them onto the new Buttons.

4) Lightly lubricate the Button/O-Ring subassemblies with applicable lubrication.

5) Install the Button/O-Ring subassemblies on top of the springs inside the Valve Body (be sure the button is

facing thick side up as shown).

6) Lightly lubricate the face of the Rotor that has air holes in it with applicable lubrication.

7) Carefully install the Rotor into the Valve Body, ensure the tapped hole on the side of the Rotor lines up with the

slot on the side of the Valve Body.

8) A press may need to be used to compress the assembly. Once the Rotor is fully depressed, carefully install the

new Retaining Ring using snap ring pliers.

Bimba Manufacturing Company

Monee, IL 60449-0068

Tel: 708.534.8544

Fax: 708 235 2014

Email: [email protected]

Website: www.bimba.com