2. Baxton Studio
  3. Leda-Grey/Dark Brown-5PC Dining Set

Baxton Studio Leda-Grey/Dark Brown-5PC Dining Set, Alena-Grey/Walnut-5PC Dining Set Assembly Instructions

  • I have reviewed the assembly instructions for the 317C chair. This document provides a detailed guide with parts lists, hardware information, and step-by-step instructions to assist you in assembling the chair. I'm here to help with any specific questions you might have about the assembly process.
  • What should I do before starting the assembly?
    When should I fully tighten the screws?
    What should I avoid when tightening screws?
C
C
B
COMPLETED TABLE ASSEMBLY
STEP 1
Read this instruction carefully, remove all wrapping material, staples and straps from the carton. See hardware and furniture part list.
For guidance. Be sure you have all wooden furniture parts on a clean and soft surface to prevent from being scratched. Follow the figure to
start assembling.
Caution:
1. Do not FULLY –TIGHTEN the nut or bolt until all nut or nut bolt is ready to assembled.
2. Do not OVER- TIGHTEN the nut or nut bolt to avoid causing damages to the thread.
3. Keep all hardware part out of reach of children.
PART LIST
No. DESCRIPTION QTY
Table Top
B
A
Table Leg
1
4
No. DESCRIPTION QTY
4
3
2
1
MODEL : 7048T
ASSEMBLY INSTRUCTIONS
HARDWARE LIST
JCBC Screw M6x90mm
JCBC Screw M6x50mm
JCBC Screw M6x25mm
1
5Spring Washer
CTable Support 2
D Bottom Support 1
6Adjuster
7
4
CSK Screw M4x30mm
8
4
12
13
1
Allen Key
STEP 2
STEP 3 STEP 4
STEP 5
A
B
C
1
57
6
2
7
5
C
5
3
7
*Please adjust table leg (set) to
center of the table top before tight
the CSK Screw M4x30mm
/