2. BLOTZ
  3. B28-JR-001

BLOTZ B28-JR-001 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Jungle Platform B28-JR-001, which provides guidance on assembling the platform using PVA glue, a sharp modeling knife, and helpful tips for securing parts during drying. I'm ready to answer any questions you might have about the assembly process or the components involved.
  • What kind of glue is required?
    What tools are needed for assembly?
    How to hold pieces while the glue dries?
28mm Jungle Platform
B28-JR-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the base and walls from the sprue.
Glue the walls to the base as shown to form an open
topped box.
Glue the “floor” to the platform.
Take the base, sides and rear of the steps….
..and glue them together as shown above.
Locate the three step supports.
Glue them into position.
Add each step, alternaing the stone pattern on
them.
The finished steps.
/