2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. Biamp
  6. EasyConnect MC1 Tabletop Cable Grommet

Biamp EasyConnect MC1 Tabletop Cable Grommet, EasyConnect MC1, EasyConnect MC1 Tabletop Cable Grommet Install User manual

  • Hello! I'm your chat assistant. I've reviewed the datasheet for the Biamp EasyConnect MC1 cable grommet. This device is designed to manage up to three cables, keeping them tidy with its retractable connectors. I'm ready to answer your questions about its features and specifications.
  • How many cables can the EasyConnect MC1 support?
    What is the maximum cable diameter supported by the grommet?
    What is the warranty period for the EasyConnect MC1?
A: 9300 S.W. Gemini Drive Beaverton, OR 97008 USA T: +1 503.641.7287 W: www.biamp.com
DATA SHEET
EASYCONNECT MC1
TABLETOP CABLE GROMMET
The EasyConnect MC1 is a cable management grommet installed in a table. Designed to eliminate cable
clutter on the tabletop, it can be equipped with up to three cables. The cables can be retracted so that the
connectors are recessed inside the grommet for a clean, finished look.
FEATURES
• Configurable: supports up to three cables
• Supports cables up to 0.25” (6 mm) in diameter
• Cable connectors are recessed/hidden inside the
grommet when not in use
• Covered by Biamp Systems’ five-year warranty
ARCHITECTS & ENGINEERS SPECIFICATIONS
The cable grommet shall be installed into the top of a table. The cable grommet shall support up to three cables. The
maximum outer cable diameter shall be 0.25 inches (6 mm). Warranty shall be five years. The cable grommet shall be
Biamp® EasyConnect MC1.
EASYCONNECT MC1 SPECIFICATIONS
Overall Dimensions
Diameter: 4.3 inches (110 mm)
Height: 3.6 inches (92 mm)
Weight: 0.5 lbs (225 g)
Included Accessories: Tension ring
Cable ribs
Cable tie holders
Cable bushings
Cable ties
Cable bag
Screws
Environmental
Ambient Operating
Temperature Range: 32 - 104° F (0 – 40° C)
Humidity: 10-90% relative humidity (non-condensing)
Altitude: 0-6,600 ft (0-2000m) MSL
Compliance:
RoHS Directive (Europe)
Biamp is either a trademark or registered trademark of Biamp Systems, LLC in the United States and other countries. Other product names referenced may be trademarks or
registered marks of their respective owners and Biamp Systems is not aliated with or sponsored by these companies.
BIADS-1051-2110-EN-R1
/