FSR HV-2HSW41-5HVT3-BTN Installation guide

Type
Installation guide

This manual is also suitable for

FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43045 LIT1468
HV-T3 INSTALLATION INSTRUCTIONS
SLOTS USED FOR 5/8" TO
1-1/8" THICK TABLE TOPS
SLOTS USED FOR 1-1/8" TO
1-9/16" THICK TABLE TOPS
3.50" DIAMETER
(2) MOUNTING
CLAMP
(2) MOUNTING
SCREW
MOUNTING
CLAMP AND
MOUNTING
SCREW
INSTALLED MOUNTING
CLAMP AND
MOUNTING
SCREW
(SEE BELOW)
HV-T3 ASSEMBLY
TABLE
DRILL 3.50" DIAMETER HOLE IN TABLE TOP.
1.
2. INSERT HV-T3 ASSEMBLY AND ORIENT AS REQUIRED.
3. INSTALL MOUNTING CLAMPS TO ASSEMBLY AND SECURE TO TABLE BY
SCREWING MOUNTING SCREWS TO UNDERSIDE OF TABLE.
MAKE ELECTRICAL CONNECTIONS AS REQUIRED. ENSURE HDMI
CONNECTOR CAN BE PULLED OUT 3'-0".
4. CUSTOMER TO PROVIDE
KO SLUG/PENNY/OTHER
HARD FLAT PIECE FOR
SCREW END, WITH SOFT
TABLE WOOD
  • Page 1 1
  • Page 2 2

FSR HV-2HSW41-5HVT3-BTN Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI