Fitting Instructions
Transport Latch Fitting Kit LMAC174
RJL 025/042005
WARNING: If incorrectly used this machine can cause severe
injury. Those who use and maintain this machine should be
trained in its proper use, warned of its dangers and should
read the entire manual before attempting to set up, operate,
adjust or service the machine.
24758G (rev.0)
AR3
1. Lower Rotary Decks to the cutting position
2. Assemble Transport Latch and hardware to
both the LH and RH side, using parts
supplied within Kit LMAC174.
LH Side (Shown Opposite) Part Numbers.
Item 1 - Disc Spring 002921109
Item 2 - Knob 002990227
Item 4 - Transport Latch LH 4137435
Item 5 - Bolt Hex M16 x 50
Item 9 - Nut Hex M16 Flange Nyloc
RH Side (Shown Opposite) Part numbers
Item 1 - Disc Spring 002921109
Item 2 - Knob 002990227
Item 4 - Transport Latch RH 4137434
Item 5 - Bolt Hex M16 x 50
Item 9 - Nut Hex M16 Flange Nyloc
TRANSPORT LATCH FITTING KIT LMAC174, AR3.
3. Assemble Bracket-Yoke stop 4138976 to
underside of operators platform to eliminate
Yoke of the RH unit contacting footpedal
mechanism, If the Decks are lowered whilst
the transport latches are still applied.
Remove front steering tower cover (4) from
Steering tower bracket.
Undo Coach bolts (25) on the RH side
securing the steering bracket tower, to the
Operators platform, and replace with longer
coach bolts M8 x 30 (452565) supplied within
LMAC174 kit.
Fit Bracket - Yoke Stop (39) in the orientation
shown and tighten in position.
TRANSPORT LATCH FITTING KIT LMAC174, AR3.
BOB-CAT BUNTON CUSHMAN JACOBSEN RANSOMES RYAN E-Z-GO
Ransomes Jacobsen Limited
West Road, Ransomes Europark, Ipswich, IP3 9TT
English Company Registration No. 1070731
www.ransomesjacobsen.com
Equipment from Ransomes Jacobsen Limited is built to
exacting standards ensured by ISO 9001 registration at
all our manufacturing locations. A worldwide dealer
network and factory-trained technicians backed by
Ransomes Jacobsen Parts Xpress provide reliable,
high-quality product support.
World Class Quality, Performance and Support
/