RJL 100 January 2011
GB
United
Kingdom
Fitting Instructions
Jacobsen GP400 Dew Whip Kit LMAC415
WARNING
WARNING: If incorrectly used this machine can cause severe
injury. Those who use and maintain this machine should be
trained in its proper use, warned of its dangers and should
read the entire manual before attempting to set up, operate,
adjust or service the machine.
25021G-GB (Rev.0)
When Performance Matters.
™
© 2011, Ransomes Jacobsen Limited. All Rights Reserved
Ransomes Jacobsen Limited
West Road, Ransomes Europark, Ipswich, IP3 9TT
English Company Registration No. 1070731
www.ransomesjacobsen.com
Jacobsen, A Textron Company
11108 Quality Drive, Charlotte,
NC 28273, USA
www.Jacobsen.com
NOTE DEW WHIP NOT SUPPLIED IN KIT
1 Secure Lower Whip Bracket, 4237603 item 10 to Rear of Toolbox/Step using the hole provided. Using M5
Pan hd screw, washer and Nyloc item 1, 2 & 13.
2) Secure both Clips 3008369 item 12 to upper whip bracket 4237602 item 9 using M4 Csk screw, washer &
Nyloc items 6, 7 & 8.
3) Attach this Sub assembly to Pre drilled holes on the RH ROPS upright, Note the upper whip bracket
attaches to the OUTSIDE face of the ROPS strengthening rib. Secure in Position using M6 Screws,
Washers & Nylocs items 3, 4 & 5
4
5
3
9
8
12
7
6
11
2
13
1
10
LOWER BRACKET - SECURE TO TOOLBOX/ STEP
NOT SUPPLIED
UPPER BRACKET - SECURE TO ROPS FRAME
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ransomes LMAC358 / LMAC359 & LMAC390 Instruction Sheet
-
-
-
Textron USAD004 Owner's manual
-
-
-
-
-
-
