Generation Lighting BA1045CRPC Installation guide

Type
Installation guide

This manual is also suitable for

1
Installation Instructions for
Avant 3 and 4 Bath
980AVANTB
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
Incandescent lamps may be dimmed with a standard incandescent
dimmer. LED lamps may be dimmed with a LED dimmer. Consult
lamp manufacturer for additional information.
1.0
BA1045, BA1046
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
Wall
Remove the fixture screws located on the top and bottom of the fixture base using the provided Allen Wrench, then remove the mounting
plate from the fixture base.
Install the mounting plate onto the electrical box with the two #8-32 screws provided.
Connect the fixture to suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Properly place all wires and wire nut connections into the electrical box, mount the fixture back onto the mounting plate, and reinstall
fixture screws (reversal of step 1A).
Install the lamps by pushing them into the sockets. Refer to the label on the socket for Max Wattage information.
Install the shades by placing them over the sockets and secure them in place by screwing the diffusers to the threads around the socket.
1
2
1A
Install the Fixture
3
4
5
6
7
8
ALLEN WRENCH
SHADE
FIXTURE SCREW
MOUNTING PLATE
FIXTURE BASE
8
DIFFUSER
SOCKET
THREAD
#8-32 SCREW
7
2
SAVETHESE INSTRUCTIONS!
1
© 2018 Lighting.All rights reserved.The " Lighting" graphic is aLBL LBL
registered trademark of Lighting. Lighting reserves the right toLBL LBL
change specifications for product improvements without notification.
7400 Linder Ave, Skokie, 60077IL
800.323.3226 - 847.626.6300
www.lbllighting.com
A Generation Brands Company
  • Page 1 1
  • Page 2 2

Generation Lighting BA1045CRPC Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI