Barco XHD-400 series Owner's manual

Brand: Barco

Model: XHD-400 series

Type: Owner's manual

AMD W-8100 Graphics Card

Cut this tie wrap

Leave this tie wrap in place

GPU Stabilizing Bracket Installation Instructions

8/27/2015 - THCA

1. After removing the chassis cover, locate

the structural support beam spanning the

chassis.

2. Loosen, but do NOT remove, the four (4)

mounting screws of the support beam.

3. You will see a USB hub cable attached to

the support beam with two tie wraps. Cut and

remove the tie wrap shown in “Illustration A”,

leaving the other tie wrap in place.

Support Beam

“Illustration A”

“Illustration B”

“Illustration C”

4. Install the GPU bracket over the AMD

W-8100 graphics card (Illustration B). The

bracket should fit around each side and over the

rear of the graphics card, and the two mounting

holes should align to the holes in the support

beam.

5. Secure the bracket to the support beam

using the two thumbscrews provided. Tighten

these screws securely using a #2 Phillips

screwdriver.

GPU Bracket

6. Tighten support beam mounting screws to

chassis on each side.

7. Using the supplied tie wrap, secure the USB

cable to the support beam through one of the

support beam mounting holes.

Kit Contains-

1- GPU Stabilizing Bracket

2- Thumbscrews

1- Tie Wrap

Tools Required-

Wire Cutters

#2 Phillips Screwdriver

Technical Service Bulletin

XHD-400 series

Secure USB cable with tie wrap

Loosen support beam mounting screws (4x)

Tighten beam mounting screws (4x)

1

Barco XHD-400 series Owner's manual

Brand: Barco

Model: XHD-400 series

Type: Owner's manual

Download PDF

Other documents