Camco 42514 Installation guide

Figure 1

Figure 2

Tighten

ASSEMBLY:

A. Thread one end of strap: (1) around center post of

buckle,

(2) through triangle ∆ ring, then (3) back around center

post

of buckle on top of strap. (See Figure 1)

B. THREAD other end of strap through the two remaining

triangle ∆ rings. (See Figure 2)

USE:

1. With hook FACING awning, drive stake securely into

ground several feet beyond end of awning. Slide triangle

∆

around hook. (See Figure 1)

2. Position free strap flat over awning.

3. Drive remaining stake securely into ground several feet

from opposite end of awning with hook FACING awning.

4. Attach opposite end of strap to stake with spring.

(See Figure 2) Pull tight.

5. Excess strap may be cut off. Sear end with a flame

to prevent raveling.

NOTE: The Camco RV Awning Hold Down Strap is

adjustable at both ends; however, the spring

end provides the most convenient adjustment.

CAUTION: This product was not intended for storm

wind conditions. For these conditions, store awning.

• Strap stays flat and neat even when tight

• Evenly distributes tension

• No loose parts to lose once assembled

• No rounded or D-rings to wrinkle strap

• No rivets to pull out

• Adjustable at both ends

CAMCO Manufacturing, Inc.

121 Landmark Dr. / Greensboro, NC 27409

1-800-334-2004 / www.camco.net

Awning Hold Down Strap Kit

Fits all awnings up to 25 ft.

z886435