Legrand ENP42805 User guide

Type
User guide
WWW.LEGRAND.US/ONQ
Please be advised that we recently made several
design modifications to the 30” and 42” Plastic
Enclosures. These updates were made to enhance the
installation experience and compatibility with the On-Q
Plastic Enclosure Trim Rings (ENP3001, ENP4201).
Modifications Include:
Flat Keyhole Hinge Design – on both the
30” and 42” Plastic Enclosures
Padlock Tab Removal – 30” Plastic Enclosure only
Reinforced Door Latch – 30” Plastic Enclosure only
Reduced Padlock hole on Door –
30” Plastic Enclosure only.
These design changes will affect the installation
process of the enclosure door. Please see details
on the next page and download the installation
instructions (link) for more information.
Plastic Enclosure
Design Modifications
WWW.LEGRAND.US/ONQ
NEW HINGE DESIGN
REDUCED PADLOCK
HOLE ON DOOR
REMOVAL OF PADLOCK
Plastic Enclosure Design Modifications
WWW.LEGRAND.US/ONQ
INSTALLATION OF NEW
FLAT KEYHOLE HINGE
Applies to both 30” and 42” Plastic Enclosure
1. Utilizing the included mounting screws,
affix the top screw halfway into the
predrilled hole in the enclosure frame
2. Rest the top door hinge onto
the screw and fasten.
3. Fasten the remaining hinge screws to the
enclosure taking caution not to over tighten.
INSTALLATION OF NEWLY
DESIGNED DOOR ON AN
OLD MODEL ENCLOSURE
Applies to the 30” Plastic Enclosure only
As we’re in the process of rolling out these
redesigned products, you may have instances
where you need to install a NEW door on an
OLD enclosure. In this case, the padlock tab
must be removed to get a strong closure on
the door. This added step is only temporary
as we complete this design transition.
1. Utilize a rotary blade / Dremel tool to cut
off the padlock tab at the base, leaving
it flush with the enclosure. If a rotary
tool is unavailable, wire cutters may be
used by clipping at the base from both
the bottom and top of the padlock tab.
2. To affix door to the enclosure, use
steps above as outlined in “Installation
of New Flat Keyhole Hinge
3. The door will close and latch to
enclosure. To lock the door to the
enclosure, apply the included Philips
head screws to the holes located on the
top and bottom corners of the door.
CLICK HERE
WATCH THE QUICK VIDEO TO SEE THE DESIGN
MODIFICATIONS AND NEW INSTALLATION PROCESS.
designed to be better
Legrand, North America
60 Woodlawn Street
West Hartford, CT 06110
1.877.BY.LEGRAND (295.3472)
www.legrand.us
570 Applewood Crescent
Vaughan, Ontario L4K 4B4
905.738.9195
www.legrand.ca
IF YOU HAVE FURTHER QUESTIONS,
OUR TECHNICAL SUPPORT TEAM IS STANDING BY TO HELP.
(717) 546-5412
8:00 a.m. - 6:30 p.m. EST (M-F)
technical.support-hs@legrand.us
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Legrand ENP42805 User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI