CAMECHO CM00-L0210 Installation guide

Install this item is a very interesting. Kindly try the following procedure steps.

1. Monitor :

The monitor has six color cables(Red / black / blue / white / green / brown ). The red wire

connected to positive 12V/24V, black wire to ground. If you use one camera as a backup

camera, Connect the color cable to 12V/24V positive power accordingly [ Green -CH1,

White- CH2 , Blue-CH3, Brown -CH4 ]. Another camera without guide line could be used

as a full time monitor.

2. The package include 2 cameras, you could add another 2 cameras and choose cable

length as your needs.

The connector is pins type, please be careful connect it correct and tightly. Every

connector has interface mark.

3. Use extend cable wiring camera to monitor V1/V2 yellow input. (there has a mark code

for every channel )

This is a operate video for your reference: https://youtu.be/cfJ26Hn0U8s

Please test item before install on vehicle.

Hope this can help you.

Any question, please contact us via camecho@163.com

Thanks

Camecho Official Shop