fig.1 fig.2
fig.3 fig.4
NewฤกBushing
P.2P.1
HYDRAULIC STEERING SYSTEM PULL TOOL SET
(49 PCS)
1. SPECIFICATION
3. REMOVE BUSHING
4. REPLACE A NEW BUSHING
2. HOW TO CHOOSE A LONG& SHORT BUSH
Choose a suitable pull spindle, short
and a long bush.
Place hydraulic cylinder, short bush,
control arm, and then long bush.
Fasten adjustable nut by hand to
connect it with long bush
Press hydraulic hand pump to
remove the bushing, the
bushing falls into long bush.
The work is done
Exchange the position of short and
long bush and fasten adjustable nut.
Press hydraulic hand pump to pull
the whole device. New Bushing will
be pulled into the control arm.
-
1
