EVOLUTION POWER SPORTS 925FP0196 RZR 200 Front Grille User manual

Type
User manual
Rev_021623
RZR 200 Front Grille with Backing Plate Kit
SKU(s): 925FP0196 (white), 925FP0197 (red)
INCLUDED PARTS
(1) Grille
(1) Backing Plate
(1) Hardware Kit
REQUIRED TOOLS
Push Dart Tool
T-40 Socket
1/16” Allen Wrench
1/4" Socket
7/64” Drill Bit
Rev_021623
Step 1: Remove (2) push darts holding the hood center piece on. Remove (2) push darts
underneath the hood center piece.
Step 2: Remove (3) push darts on both front fenders.
Rev_021623
Step 3: Unplug both low/high beam connectors, located underneath the hood.
Step 4: Remove (4) T-40 screws holding the front clip onto the vehicle. (2) are located in the
front of the vehicle under the headlights. The other (2) are located underneath the car
where the A-arms connect to the frame. Now remove the front clip.
Rev_021623
Step 5: Install the backing plate to the grille. Use supplied hardware to fasten down.
Step 6: Cut out the OEM grill with an air attachment or cutters. File any rough edges and use
some heat to de-bur. Leave the 1/2" trim piece in contact. You will need to mount the
grille to the trim.
Rev_021623
Step 7: Lay the grille into the front clip. With a 7/64” drill bit, drill through each hole and install
supplied hardware. Use a 1/16” Allen wrench and 1/4" socket to fasten down. DO not
over tighten.
Step 8: Reinstall the front clip with all hardware. Don’t forget to reconnect the low/high beam
connectors.
Rev_021623
Thank you for choosing Evolution Powersports products. If you require further assistance, please call our Tech
Support @ (715) 247-3862
Note: This product is exempt from the emission standards and related requirements of 40 C.F.R. § 1051 as provided
by 40 C.F.R. § 1051.620, and California law [e.g., vehicle code§§ 27156 and 38391]. This product is sold only for use
in connection with EPA certified, purpose-built, nonroad vehicles used solely for closed course, nonroad
competition/racing and not used for any recreational purpose or on public highways or right of ways maintained by
and open to the public. This product is sold only in connection with machines that do not fall under state and/or
federal noise or emission standards/regulations. Purchasers who/that purchase this product represent and warrant
that the product is purchased only in connection with EPA -certified, emission-regulations-exempt and noise-
regulations-exempt competition/racing vehicles as interpreted under applicable state and/or federal law. Questions:
Call Evolution Powersports at (715) 247-3862.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

EVOLUTION POWER SPORTS 925FP0196 RZR 200 Front Grille User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI