2. Avaya
  3. Bogen UL Listed (UUMW) Flush-Mounted Loudspeaker Enclosure

Avaya Bogen UL Listed (UUMW) Flush-Mounted Loudspeaker Enclosure User manual

  • Hello! I am an AI chatbot trained to assist you with the Avaya Bogen UL Listed (UUMW) Flush-Mounted Loudspeaker Enclosure User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
PEC Code: 5335-030
COM Code: 408184562
Model: LURCSE
Lucent Technologies
Bell Labs Innovations
UL Listed (UUMW) Flush-Mounted
Loudspeaker Enclosure for Use in Return
Air Ceiling Plenum Spaces
NOTE: Listed by Underwriters Laboratories, Inc., Category UUMW Material and construction permits use where ceiling
plenum is part of the air handling system.
A listed assembly requires that the enclosed loudspeaker is not exposed within the air handling plenum. Wiring,
and/or conduit enclosure entry fittings, and installation must comply with local codes. Many local codes require a sep-
arate enclosure assembly "tie-off" wire to be secured to the top of the ceiling cavity.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
- Ceiling tile hole: Cut an 8½" square hole using the support bridge as a template.
- Bend up the four horseshoe tabs on the support bridge.
- Position the support bridge on the tile and bend the eight locator tabs into the tile opening.
- Install the UL Listed metallic enclosure entry fitting to the knockout to accommodate quarter-inch
(plenum) cable, plenum whip, or plenum cable.
- Install the enclosure to the bridge by orienting the four enclosure slots over the four horseshoe tabs of
the bridge.
- With pliers, twist the four horseshoe tabs on the bridge one-half turn, securing the enclosure to the bridge.
- Install the Speaker/Baffle assembly with the four supplied screws. (See illustration below).
Speaker/Baffle Assembly
Compound knockouts provided for metallic UL Listed fittings for ½"
and ¾" plenum rated cable and plenum whip flex conduit.
Note: Four slots provided on each
enclosure to mate with four twist tabs on
support bridge eliminates need for screws.
Note: All cable splices and connections
to Speaker Transformer pigtails must be
made inside of Listed enclosure.
Note: Use 22 AWG Shield, twisted pair
on all wire runs Com Code: 401882956.
Pec Code: 2734-SPK
Issue 1, October 1999
Specifications subject to change without notice.
© 1999 Bogen Communications Inc. All rights reserved.
Part No. 54-2029-01 Printed in USA 9910
Select Code: 701-000-103
/