Whirlpool AKT 151/IX User guide

Brand: Whirlpool

Model: AKT 151/IX

Type: User guide

5019 319 01073

AKT 151 PRODUCT DESCRIPTION SHEET

PL CZ SK HU BG RO SL HR GB

• To use the hob turn the knob(s) clockwise and position

it (them) on the required power setting or symbol

(each number/symbol corresponds to a different power

setting/function).

• To switch off the hob return the knob(s) to position “0”.

• Cooktop functions are explained in the separate “Oven

Product Description Sheet”.

N.B.: The cooling fan runs continuously at different

speed according to the temperature value of the

components when the cooktop or the oven are in use.

The fan may continue to run for the time necessary to

ensure sufficient cooling of the components and adjacent

kitchen units after the appliances have been switched off.

Important:

To avoid permanently damaging the glass-ceramic top,

do not use:

- Pots with bottoms that are not perfectly flat.

- Metal pots with enamelled bottom.

Any aesthetic defects (scratches, marks etc.) must be

reported at the time of installation.

DIMENSIONS OF COOKING HOB AND WORKTOP (mm)

1. Radiant cooking zone Ø 145

2. Radiant cooking zone Ø 180

3. Radiant cooking zone Ø 145

4. Radiant cooking zone Ø 210

5. Residual heat indicator lamps

Type PFEVS 230 V ~ 50 Hz 6.2 kW

Assembly

A) If the worktop is made of wood, use the

appropriate brackets, spring clips and screws

provided.

• Position the 4 clips (A), if not alreay fitted, around

the cooktop frame, in the slots provided, see Fig. 1.

• Measure the centre of the vertical sides of the cut

out a shown in Fig. 2.

• Position the centre of the brackets (C) on the

centre of the side previously identified.

• The upper edge of the brackets must be flush with

the worktop surface.

• Secure using the 4 screws (B) provided that should

screwed into the pre-prepared holes.

• Insert the cook hob into the pre-prepared hole

ensuring that the clips (A) lodge into the bracket

slots provided (C Fig. 4 and 5).

B) If the worktop is made of marble or other

materials (plastic compounds, ceramics, stone,

etc.), the hob must be fitted by means of brackets

code 4819 310 18528.

(to be ordered from After-Sales Service if not

provided).

• Fit the hob into the worktop.

• Position the brackets (C) as shown in the figure, in

accordance with the thickness of the worktop.

• Secure the screws (E) in holes (D).

Fig. 2

Fig. 1

Fig. 3

Fig. 4

Fig. 5

Top min. 20 mm

Top max. 50 mm

Whirlpool AKT 151/IX User guide

Whirlpool AKT 151/IX User guide

Whirlpool AKT 151/IX User guide

Related papers

Other documents