Solution: Run the command prompt as administrator and navigate to Power PMAC
Suite Folder and type “PowerPmacSuite.exe” /setup and press ENTER. Please monitor
“PowerPmacSuite.exe” under the “Processes” tab in the Task Manager. Once it’s done,
you can delete %PPSystemRoot% folder from desktop and start the IDE.
3. Project Examples in the start menu won’t open in the new instance of Power PMAC
IDE
Solution:
Set the following registry
HKCU\Software\Microsoft\Windows\CurrentVersion\Explorer\FileExts\(
whatever extension u want)\OpenWith
HKCU\Software\Microsoft\Windows\CurrentVersion\Explorer\FileExts\(
whatever extension u want)\OpenWithProgids
For example:
HKCU\Software\Microsoft\Windows\CurrentVersion\Explorer\FileExts\.Pow
erPmacSuite_sln\OpenWith key with
Name “a”
Value: PowerPmacSuite.exe (some times its POWERPMACSUITE.EXE)
Name MRUList
Value: a
4. Do you want to overwrite the file while unzipping project examples?
Reason: Installation will delete the old examples in the project examples folder. If there
is any problem then few files will be left over in that folder. So, when unzipping
projectexamples.exe file, it will ask whether to overwrite or not.
Solution:
o Make sure while installing/repairing close the windows explorer pointing to
Power PMAC Suite folder.
o Type “A” and press ENTER
5. This application needs valid shell load key.
Reason: This could be because of your virus scan or firewall which is trying to block our
.exe files and the files which needs to update the registry.
Solution: Please disable your firewall or virus scan and start IDE installation. Once it’s
successful, you can enable/turn on the virus scan or firewall.
6. Repair not overwriting any files to the installation folder.
Solution: Please uninstall the IDE and reinstall the IDE as fresh installation.
7. Installation Aborts If