Cornelius Millennium II Base Keylock Kit 629 Installation guide

Brand
Cornelius
Model
Millennium II Base Keylock Kit 629
Type
Installation guide
Millennium Base Keylock Kit Installation Instructions
© 2002-2014, Cornelius Inc. - 1 - Publication Number: 620919572
INSTALLATION INSTRUCTIONS
Millennium Base Key lock Kit (P/N 629087548)
S
AFETY INSTRUCTIONS
!
WARNING:
Before starting installation, read and understand all safety label and warnings on the machine. Also review and
understand all safety instructions in the owners, installation and service manuals.
Failure to comply could result in serious injury, death or damage to the equipment.
QUALIFIED SERVICE PERSONNEL
!
WARNING:
Only trained and certified electrical, plumbing and refrigeration technicians should service this unit.
All wiring and plumbing must conform to national and local codes. Failure to comply could
result in serious injury, death or equipment damage.
SAFETY PRECAUTIONS
This unit has been specifically designed to provide protection against personal injury. To ensure continued
protection observe the following:
!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all
power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
CAUTION:
!
Always be sure to keep area around the unit clean and free of clutter.
Failure to keep this area clean may result in injury or equipment damage.
Revision Date: March 24, 2014 www.cornelius.com Revision: C
Millennium Base Keylock Kit Installation Instructions
Publication Number: 620919572 - 2 - © 2002-2014, Cornelius Inc.
INSTALLATION INSTRUCTIONS
This instruction applies to Millennium 2 Models for converting top panel key lock operation to a key lock mounted
into the dispenser base.
1. Unplug the unit from electrical power.
2. Disassemble Merchandiser, Drip Tray, Splash Plate as needed and disconnect existing Key lock connector
from the Transformer Harness.
Figure 1.
3. Install the Key lock included in this kit into the hole on either the left or the right side of the Base. Tighten
the Key lock nut securely.
Figure 2.
Replacement Parts List
Part Number Description
620316408 Wire Harness
33300 Key lock (Includes Key)
Millennium Base Keylock Kit Installation Instructions
© 2002-2014, Cornelius Inc. - 3 - Publication Number: 620919572
4. Install the Wire Harness included with this kit onto the new Key lock terminals and onto the Transformer
harness. Route Wire Harness to avoid interference with internal components.
Figure 3.
5. Remove the old Key lock. Re-assemble Splash Plate, Drip Tray, etc.
Figure 4.
6. Operate dispenser, check for proper operation of the new Key lock.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Cornelius Millennium II Base Keylock Kit 629 Installation guide

Brand
Cornelius
Model
Millennium II Base Keylock Kit 629
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents