Battery Eliminator Kit
User’s Guide
PA-BEK-001CG/WR
Before using this product, be sure to read this user's guide.
We suggest that you keep this manual in a handy place for future
reference.
Version 0
ENG
i
Introduction
Important Notice
The contents of this document and the specifications of this product are subject to change without notice.
Brother reserves the right to make changes without notice in the specifications and materials contained
herein and shall not be responsible for any damages (including consequential) caused by reliance on the
materials presented, including but not limited to typographical and other errors relating to the publications.
Before using the printer and the Battery Eliminator Kit, make sure you read all the documents included with
them for information about safety and operation.
The printer shown in the illustrations may be different from your printer.
Use the Battery Eliminator Kit only with printers that have firmware version 1.20 or later.
Symbols Used in This Guide
The following symbols are used throughout this guide:
Important Safety Instructions
CAUTION
Brother is not liable for damage to any equipment caused by improper installation of this equipment to any
power source.
Important
• The Battery Eliminator Kit must be securely installed and NEVER installed where it may come in close
contact with the vehicle operator or passenger.
• DO NOT use the printer while driving, otherwise this may result in property damage or personal injury.
• Ensure the power cables are correctly connected before applying power. Incorrectly connected power
cables can cause serious injuries and damages.
CAUTION
Failure to observe instructions and warnings could result in minor or moderate
injuries.
Follow these guidelines to avoid injury.
Important
Indicates information or directions that should be followed. Ignoring them may result
in damage or failed operations.
Note
Indicates notes that provide information or directions that can help you better
understand the product and use it more efficiently.
1
1
1
a Unlock and pull out the printer’s battery cover.
b Insert the Dummy Battery Pack assembly until it locks into place.
1 Dummy Battery Pack
Note
DO NOT lose the battery cover as you will need to reattach it later.
c Connect the Joint Cable of the Power Adapter (2) and the Power Cable of the Dummy Battery Pack (3)
until they lock into place.
1 Power Adapter
2 Joint Cable (Output)
3 Power Cable (Input)
Note
The plugs are polarized to ensure correct installation. They can only be connected one way. DO NOT
attempt to force a connection.
Install the Dummy Battery Pack 1
1
1
2
3
2
2
2
Connect the Battery Eliminator to your vehicle’s 12 V DC power socket (cigarette lighter or similar).
a Connect the Cigarette Socket Adapter or the Bare Wire Connector into the vehicle’s 12 V DC power
socket.
1 Cigarette Socket Adapter
2 Bare Wire Connector
Note
If installing the Bare Wire Connector type, follow good wiring practices and connect it to a fused connection
point on the vehicle electrical fuse block. The positive lead (red wire) contains the fuse holder.
b Check that the LED indicator of the Power Adapter is lit in green.
1 LED Indicator
Note
If the LED is lit in red:
a) Disconnect the printer from the power supply.
b) Turn off the vehicle power.
c) Reconnect the printer to the power supply.
If the LED color is still red, contact your local Brother dealer.
Connect the Battery Eliminator to the
Vehicle Power Supply
2
Vehicle's 12 V DC
Power Socket
Printer
Vehicle Power Supply
2
1
1
Connect the Battery Eliminator to the Vehicle Power Supply
3
2
c Turn on the printer. The connection icon appears on the printer's LCD when the Battery Eliminator is
connected.
d Install the correct media in the printer.
e Press the Feed button to check that the printer is correctly connected and the media has been correctly
installed.
Note
The printer can print only if the vehicle power is on.
-
1
-
2
-
3
-
4
-
5
-
6
Brother RJ-4250WB User guide
- Type
- User guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Brother RJ-4250WB User guide
-
Brother PJ-523 User manual
-
Brother PJ-763 User manual
-
Brother PocketJet PJ673-K User manual
-
Brother RJ-2150 Quick setup guide
-
Brother RJ-4030 User guide
-
Brother PJ623 PocketJet 6 Plus Print Engine User manual
-
-
-
Other documents
-
Zebra ZQ500 Installation guide
-
-
Zebra RW 420 Owner's manual
-
Amazon Renewed ZQ51-AUN010E-00 Datasheet
-
-
-
-
-
Intermec PB41 User manual
-