Overland Storage ULTAMUS RAID 4800 Remove & Replace / Add-On Instructions

Type
Remove & Replace / Add-On Instructions
Part Number 10400124-101 06/2007 ©2007 Overland Storage, Inc. W Page 1 of 2
CAUTION: Be sure replacement parts are acclimated to
room temperature (test by touching) before installing.
CAUTION: Improper installation may result in damage to
the unit or RAID array which voids the unit warranty.
CAUTION: To ensure adequate drive cooling, the lid of
the enclosure must be fully closed during operation.
This document describes how to remove and replace or
install additional disk drives in an Overland ULTAMUS
RAID 4800 Storage Appliance or Expansion Unit.
Electrostatic Discharge Information
A discharge of static electricity can damage micro-circuitry
or static-sensitive devices. To help prevent Electrostatic
Discharge (ESD), observe standard ESD precautions.
ULTAMUS RAID disk drives come pre-installed in a drive
carrier with a latch mechanism. The procedure for
replacing a drive is similar to one for adding more drives.
1. Pull the enclosure from the rack cabinet just enough to
expose the drive slots.
The lid is retained in the rack as the enclosure slides
forward (Figure 1).
Figure 1. Drive Slots Exposed
2. If replacing a drive, remove the old drive carrier:
a. Release the drive carrier handle by sliding the latch
towards the front of the enclosure and pivoting the
handle to the upright position. (Figure 2)
Figure 2. Releasing the Drive Carrier Latch
b. Using the raised handle, pull the drive carrier up
and out of the enclosure, setting it aside.
3. Insert the drive carrier into the enclosure (Figure 3):
Figure 3. Installing a Drive Carrier Module
a. Release the handle on the new drive carrier.
ULTAMUS RAID 4800
Disk Drive Spare
Remove & Replace/Add-On Instructions
Overview & Notes
TM
Drive Installation
Part Number 10400124-101 06/2007 ©2007 Overland Storage, Inc. W Page 2 of 2
b. Slide the drive carrier all the way into the enclosure.
IMPORTANT: Ensure that the drive carrier is
orientated so that the handle opens towards the
front of the enclosure.
c. Seat the drive carrier - the camming foot of the
carrier engages into a slot in the drive bay.
d. When the drive carrier is fully seated, close the
handle. (Figure 4)
A click should be heard as the latch engages and
holds the handle closed.
4. Repeat Steps 2–3 as needed until all the appropriate
drives are replaced or the enclosure is populated with
the desired amount of disk drives.
5. Close up the enclosure by sliding it back into the rack.
Figure 4. Securing a Drive Carrier Module
All information contained in or disclosed by this document is considered proprietary by Overland Storage. By accepting this material, the recipient agrees that this material and the information contained therein are held in confidence and in trust and will not be
used, reproduced in whole or in part, nor its contents revealed to others, except to meet the purpose for which it was delivered. It is understood that no right is conveyed to reproduce or have reproduced any item herein disclosed without express permission from
Overland Storage. Overland Storage provides this document as is, without warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Overland Storage may make
improvements or changes in the product(s) or program(s) described in this document at any time. These changes will be incorporated in new editions of this publication.
Overland Storage assumes no responsibility for the accuracy, completeness, sufficiency, or usefulness of this document, nor for any problem that might arise from the use of the information in this document.
Additional Help
You can get additional technical support on the Internet at http://support.overlandstorage.com, or call
1-877-654-3429 (toll-free U.S. & Canada), +44 (0) 118-9898050 (Europe), or +1 (858) 571-5555 Option 5 (International).
  • Page 1 1
  • Page 2 2

Overland Storage ULTAMUS RAID 4800 Remove & Replace / Add-On Instructions

Type
Remove & Replace / Add-On Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI