Genius Easywave TX4 Operating instructions

Page is loading ...

FOUR-CHANNEL RADIO CONTROL

ADVICE ON SAFETY

• Before using the radio control, carefully read the whole

of the instructions manual.

• Use the radio control only at a distance that allows

you to visually control the automated system during

the whole of its movement.

• If the equipment does not work, strictly contact GENIUS

qualified personnel or GENIUS service centres.

• GENIUS is not responsible for problems caused by

improper use of the radio control.

• The radio control can only be used when combined

with an EASYWAVE receiver.

• DO NOT, ON ANY ACCOUNT, MODIFY THE CONTROL

DEVICE.

1. CONTENTS OF THE PACKAGE

The following items are inside the package:

• 1 single channel transmitter with integrated battery

• 1 wall support

• 1 accessories package for fastening

• 1 use manual

2. TECHNICAL SPECIFICATIONS

Description Value

Power supply 1 battery 3V (CR2032)

Absorbed current 10 mA

Frequency 868.30 MHz

Modulation FSK

Operating ambient tem-

perature

-20°C ÷ +60°C

Range

~ 100 m (outdoors)

~ 30m (indoors)

Dimensions

110x38x14 mm (without wall

support)

Weight

37 g (with battery and without wall

support)

3. OPERATIONAL PRINCIPLE

The radio control is used for commanding the movement of

curtains or roller-shutters indoors or outdoors.

With reference to figure 1, the lay-out of the remote-control is

described in the following table:

Ref. Description

a

UP push-button

b

STOP Push-button

c

DOWN push-button

d

CHANNEL SELECTION push-button

e

LED signalling channel active

f

On-wall support

The following can be commanded with the radio control:

• A maximum of four channels enabled individually or simul-

taneously.

• One or more operators for every single channel.

You select the channel and therefore the motors you wish to

command by scrolling the LED (fig.1 ref. e) with push-

button 4 (Fig. 1):

LED 1: CHANNEL 1 = All motors associated with channel 1

LED 2: CHANNEL 2 = All motors associated with channel 2

LED 3: CHANNEL 3 = All motors associated with channel 3

LED 4: CHANNEL 4 = All motors associated with channel 4

LED 1,2,3,4: CHANNEL 1,2,3,4= All motors associated with the

4 channels

4. COMMISSIONING

• Fasten the wall support (Fig.1 ref. d) using the supplied

accessories.

The wall support must be installed out of reach of chil-

dren.

• The radio control is supplied with a pre-installed internal

battery and can be used immediately.

• Transfer the radio control code to the receiver coupled to

the motor you wish to control. To carry out this operation

correctly, consult the receiver board instructions, if using

the external receiver. For operators with a built-in receiver,

refer to the motor instructions.

5. USING THE RADIO CONTROL

The three keys on the radio control, see Fig. 1, enable you

to command opening, key a, closing, key c, or motor stop,

key b.

To command the opening or closing of the curtain/roller

shutter, brief pressure of the appropriate key is sufficient,

without holding it down. Whenever one of the keys is pres-

sed, the LED (Fig. 1 ref. e) on the radio control lights up. The

following table specifies thebehaviour of the keys during the

individual stages:

Status

Commands

Open Stop Close

Closed Opens No effect No effect

At opening No effect

Stops

movement

Reverses on

closing

Open No effect No effect Closes

At closing

Reverses on

opening

Stops

movement

No effect

Stopped Opens No effect Closes

6. REPLACING THE BATTERIES

Procedure for replacing the radio control battery:

a Insert a coin in the slot on the lower part of the radio control

(Fig. 2 ref.a) and turn it until the radio control opens.

b Withdraw the battery in the direction of the arrow.

c Insert the new battery and close the radio control.

• Respect the polarity indicated in Fig. 2.

• Strictly use only batteries with the characteristics

indicated in table a of paragraph 2.

Discharged batteries must be returned to the seller or left

in the collection containers. Do not leave exhausted

batteries in the environment.

7. CONFORMITY

This product conforms to Directive 99/05/EEC

Page is loading ...

Le descrizioni e le illustrazioni del presente manuale non sono impegnative. GENIUS si riserva il diritto, lasciando inalterate le caratteristi-

che essenziali dell’apparecchiatura, di apportare in qualunque momento e senza impegnarsi ad aggiornare la presente pubblicazione,

le modifiche che essa ritiene convenienti per miglioramenti tecnici o per qualsiasi altra esigenza di carattere costruttivo o commerciale.

The descriptions and illustrations contained in the present manual are not binding. GENIUS reserves the right, whils leaving the main features

of the equipments unaltered, to undertake any modifications to holds necessary for either technical or commercial reasons, at any time

and without revising the present publication.

Les descriptions et les illustrations du présent manuel sont fournies à titre indicatif. GENIUS se réserve le droit d’apporter à tout moment

les modifications qu’elle jugera utiles sur ce produit tout en conservant les caractéristiques essentielles, sans devoir pour autant mettre

à jour cette publication .

Las descripciones y las ilustraciones de este manual no comportan compromiso alguno. GENIUS se reserva el derecho, dejando inmutadas

las características esenciales de los aparatos, de aportar, en cualquier momento y sin comprometerse a poner al día la presente publi-

cación, todas las modificaciones que considere oportunas para el perfeccionamiento técnico o para cualquier otro tipo de exigencia

de carácter constructivo o comercial.

Die Beschreibungen und Abbildungen in vorliegendem Handbuch sind unverbindlich. GENIUS behält sich das Recht vor, ohne die wesentli-

chen Eigenschaften dieses Gerätes zu verändern und ohne Verbindlichkeiten in Bezung auf die Neufassung der vorliegenden Anleitungen,

technisch bzw, konstruktiv / kommerziell bedingte Verbesserungen vorzunehmen.

De beschrijvingen in deze handleiding zijn niet bindend. GENIUS behoudt zich het recht voor op elk willekeurig moment de veranderingen

aan te brengen die het bedrijf nuttig acht met het oog op technische verbeteringen of alle mogelijke andere productie- of commerciële

eisen, waarbij de fundamentele eigenschappen van het apparaat gehandhaafd blijven, zonder zich daardoor te verplichten deze

publicatie bij te werken.

Timbro rivenditore: / Distributor’s stamp: / Timbre de l’agent: / Sello del revendedor: / Fachhändlerstempel: / Stempel

dealer:

Via Padre Elzi, 32

24050 - Grassobbio

BERGAMO-ITALY

tel. 0039.035.4242511

fax. 0039.035.4242600

[email protected]

www.geniusg.com

00058I0666 Rev.0

Genius Easywave TX4 Operating instructions

Genius Easywave TX4 Operating instructions

in other languages

Related papers

Other documents