2. Intelligent Motion Systems
  3. MD-CC100-000

Intelligent Motion Systems MD-CC100-000 User manual

  • Hello! I am an AI chatbot trained to assist you with the Intelligent Motion Systems MD-CC100-000 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pin 1
Pin 2 - SPI Clock
Pin 3 - MOSI
Pin 4 - SPI Chip Select
Pin 15 - MISO
Pins 18-25
Ground
To Customer PC
Parallel/SPI Port
To 10 Pin Header
Cable Length
6 Feet (1.8 M)
Red Wire
# 1 Pin
Standard DB-25
Parallel/SPI Connector
intelligent motion systems, inc.
Excellence in Motion
TM
370 N. MAIN ST., PO BOX 457, MARLBOROUGH, CT 06447
PH: (860) 295-6102, FAX: (860) 295-6107
Internet: www.imshome.com, E-Mail: [email protected]
TM
MD-CC100-000
Parameter Setup Cable
The MD-CC100-000 Parameter Setup Cable is de signed to be
used with the following IMS products:
MDrive14*
MDrive17 Microstepping* and Speed Control Versions
MDrive23 Microstepping* and Speed Control Versions
MDrive34 Microstepping and Speed Control Versions
USC-48-2 Universal Speed Control
* The MDrive14, MDrive17C and MDrive23C are equipped with C Connector and
require an Adapter Cable to interface with the MD-CC100-000. The optional
Prototype Development Cable is also recommended for these products.
23
4
15
19
PIN 4 - CS
GND - PIN 5
MOSI - PIN 7
PIN8-CLOCK
PIN 6 - +5VDC OUT
PIN 10 - MISO
10 Pin Header
P2
Ground
DB-25 Standard
PC Parallel/SPI Port
Parameter Setup Cable Usage
SPI Interface
SPI Pin Assignments
Description
The MD-CC100-000 Parameter Setup Cable eliminates
the need for the user to wire communications to the IMS
product. In clud ed in this cable is built-in logic level shifting
cir cuit ry to ac com mo date the 3.3v ports on some PCs.
This cable plugs in easily to con nect a stan dard DB-25
PC Parallel/SPI port to the 10 pin header.
For More Information:
See each product’s complete manual
on the IMS Product CD or at www.imshome.com
Copyright © 2003–2004 Intelligent Motion Systems, Inc.Revision 102104
Details
WARNING! The +5VDC output is used for the setup cable
ONLY! This output is not designed to power external devices!
10 Pin Header
Pin # Pin Name Description
1 N/C No Connect
2 N/C No Connect
3 N/C No Connect
4 CS Chip Select
5 GND Communications Ground
6 +5VDC +5VDC Output (See Warning Below)
7 MOSI Master Out – Slave In
8 CLK Clock
9 N/C No Connect
10 MISO Master In – Slave Out
WARNING! DO NOT connect or disconnect the MD-CC100-000
Parameter Setup Cable while power is applied!
/