2. Savoy House
  3. 3-1773-6-320

Savoy House 3-1773-6-320 User manual

  • Hello! I have reviewed the assembly instructions for the SAVOY HOUSE Light Fixture 3-1773-6-320. The document provides a detailed guide on how to assemble the fixture, including attaching the center rods, glass shade, and canopy using the quick link mechanism. It also covers basic wiring instructions and bulb installation procedures. I'm ready to help you with any questions you might have about the assembly process.
  • What should I do before starting the assembly process?
    How do I attach the glass shade?
    What is used to connect the canopy and center rod?
CENTER ROD(C)
CENTER ROD(D)
CANOPY(E)
FIXTURE BODY(A)
GLASS SHADE(B)
ASSEMBLY INSTRUCTIONS
1. Carefully unpack and identify all parts referring to illustration for parts identification.
2. Turn the power to the installation point OFF.
3. Unravel the supply power and ground wires and pass them through the center holes of center rods
(B),(C), and canopy (D).
4. Carefully place the glass shade (B) over the fixture body (A) as shown in the diagram.
5. Align the hole of the glass shade (F) with the hole on iron plate of the fixture body (A), and secure
with screws (G) (not pictured).
6. Thread the bottom of center rod (C) to the fixture body (A). Repeat process for remaining center
rods (C) and (D). Hand tighten until snug.
7. Use quick link (F) to connect the top loop on center rod (D) to the loop on the canopy (E) and twist
the locking mechanism to secure.
8. Refer to the additional installation instructions included with the product for wiring and installation.
9. Install proper bulbs (not included) into each socket referring to the markings and/or labels on the
fixture for maximum wattage.
10. Restore power to the installation point and retain this sheet for future reference.
ITEM NO: 3-1773-6-320
QUICK LINK(F)
/