2. Dynojet
  3. 91012001
91012001

Dynojet 91012001 Installation guide

  • Hello! I've reviewed the installation guide for the Dynojet Velocity Stacks designed for BMW R1200GS, R1200R, R1200RT and R1200RS models. This document outlines the steps for replacing your stock velocity stacks and includes a parts list. I can answer any questions you have about this installation procedure.
  • What BMW models are compatible with these velocity stacks?
    What parts are included in the kit?
    What should I do before starting the installation?
BMW Velocity Stacks
2 VELOCITY STACKS
2 HOSE CLAMPS
PARTS LIST
IPC6-10001.01
Install guide for 91012001
Fitment for:
2014-2018 BMW R1200GS
2016-2018 BMW R1200R
2016-2018 BMW R1200RT
2015-2018 BMW R1200RS
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.
2 BMW VELOCITY STACKS INSTALLATION GUIDE
1 Remove the seat.
2 Remove the bodywork around the fuel tank / airbox
area.
3 Remove the airbox lid to access the air filter.
4 Remove the air filter
5 Remove the clamps from the intake boot to the airbox
on each side of the motorcycle.
These clamps can be reused if desired by using
special pliers
6 From the inside of the airbox grab the stock velocity
stack and pull it out of the rubber boot.
INSTALLING THE VELOCITY STACKS
91012001
INSTALLING THE VELOCITY STACKS
7 Install the Dynojet velocity stacks in place of the
stock part.
Make sure to align the tab on the velocity stack with
the mark on the airbox. Ensure the velocity stack is
fully seated within the rubber boot.
8 Reinstall the stock clamps or use the supplied clamps
in the kit.
9 Reinstall the air filter and bodywork.
© 2010-2020 DYNOJET RESEARCH ALL RIGHTS RESERVED
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.COM
/