ShenZhen i-LedShow Technology Co.,Ltd.
6. Connect
1. Press and hold the power button on the screen, the screen will automatically turn on for about 2 seconds, the
screen will first display the Bluetooth id number (eg: 0202), and then enter the normal display mode
2. Open the software, if the bluetooth is not turned on, a dialog box asking to turn on the bluetooth will pop up,
please click Allow to turn on the bluetooth connection device
3. After clicking OK, the application software will search for the currently opened display device. If there are more
than one, please click the corresponding device to connect. After a few seconds, the device is connected
successfully, as shown in the figure:
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
