Page is loading ...
StructuredWiringSolutions
E
Installation Guide
ESWV10400/ESWV10800
Instruction Leaflet IL00412017E
New Information
Effective January 2007
Description
The Eaton ESWV10400 and ESWV10800 Coaxial Distribution
Modules provide distribution of one incoming coaxial signal (TV and
CATV) to four or eight locations with four pass-through connections
for SATV. Please be sure to review this installation guide carefully
prior to installation.
Features
Video Distribution
●
Distributes one incoming video signal to four or eight locations.
●
Four pass-through connections for satellite TV distribution.
●
Passes infrared signals.
●
Bi-directional for digital and HD video signals.
Passive Coaxial Distribution Modules
m
CAUTION
INSTALLATION PRECAUTIONS:
NEVER INSTALL OR WORK WITH VIDEO WIRING DURING A LIGHTNING STORM.
NEVER INSTALL TELEPHONE JACKS IN WET LOCATIONS UNLESS THE JACK IS
SPECIFICALLY DESIGNED FOR USE IN WET LOCATIONS.
HAVE THE ELECTRICIAN CONNECT THE AC OUTLET TO BRANCH CIRCUIT
POWER. THE CONNECTION SHOULD BE IN ACCORDANCE WITH THE NATIONAL
ELECTRICAL CODE
T
, ARTICLES 110, 250, AND 300.
NEVER TOUCH UNINSULATED TELEPHONE WIRES OR TERMINALS UNLESS THE
TELEPHONE LINE HAS BEEN DISCONNECTED AT THE NETWORK INTERFACE OR
D-MARCATION POINT.
© 2007 Eaton Corporation
All Rights Reserved
Printed in USA
Publication No. IL00412017E / Z5272
January 2007
Connecting the ESWV10400/ESWV10800
Connecting Incoming Television or Cable TV to the
Coaxial Distribution Module
1. Run a RG6 coaxial cable from the video source (antenna or cable
TV D-marc) location to the ESWV10400 or ESWV10800.
2. Connect the RG6 cable to the RF input located on the rear of the
coaxial distribution module. See
Figure 1
.
3. Connect the RG6 coaxial cable running to the various room
locations to the coaxial connectors on the front of the module
marked Outputs. See
Figure 2
.
Connecting to Satellite Signals
1. Run two, three, or four RG6 cables from the satellite dish to the
ESWV10400 or ESWV10800 modules and connect the cables to
the SATV connectors on the rear. See
Figure 1
.
2. Connect the RG6 cables running to the various satellite receiver
(room) locations to the inputs on the front of the ESWV10400 or
ESWV10800 module. See
Figure 2
.
FIGURE 1.
FIGURE 2.
Input
SATV
Connections
Outputs to Room Locations
Four Pass-Through
Connections for SA
TV
/
