INTRODUCTION
1.3
lndoor Unit
DLF
The DLF DCI indoor unit is a low silhouette ducted unit and low noise level (up to 29
DBA), can be easily fitted to many type of residential and commercials applications.
•
Low silhouette units 200mm height.
•
High technology plastic fan and fan housing.
•
Drain pool at bottom of unit with internal downward slope.
•
Over-low switch, stops compressor operation in case of a blocked drainage.
•
Integrated water pump
•
Hydrophilic coated aluminum fins coil.
•
DC fan motor with maximum fan speed flexibility.
•
Easy installation and service access.
(1) Horizontal/Vertical installation build in.
(2) 2 options of return air location, on back of the unit or bellow the unit.
•
lnfrared remote control with liquid display unit (LCD).
•
Advanced electronic control box assembly with 1 meter cable to allow installation at
a more accessible area.
1.4
Filtration
•
The unit is equipped with pre filters.
•
The air filter can be located in the back side or in the bottom of the unit for easy
access.
1.5
Control
The micro processor indoor controller, and an infrared remote control, supplied as
standard, provides complete operating function and programming.
For further details, please refer to the Operation Manual, Appendix A.
1.6
Outdoor Unit
The DCI outdoor units can be installed as floor or wall mounted units by using a wall-
supporting bracket. The metal sheets are protected by anti- corrosion paint work
allowing long life resistance. All outdoor units are pre-charged. For further information,
please refer to the Product Data Sheet, Chapter 2.
•
Compressor mounted in a soundproofed compartment.
•
lmproved 3-blades axial fans for noise reduction.
•
Outdoor coil with hydrophilic fins optimized for operation with R410A refrigerant.
•
Fan grill air outlet.
•
Service valves “flare” type connection.
•
Service ports for high/low pressure measurement.
•
Interconnecting wiring terminal blocks.
1-2
SM DLF 1-A.1 GB