2. Enwork
  3. GRID™

Enwork GRID™ Installation guide

  • Hello! I've reviewed the Installation Instructions for the Grid GI0002 Topper Screen. This document details the proper steps for installing the acrylic screens, including using soapy water to facilitate insertion into the top cap. I'm ready to assist with any questions you may have about the installation process or the product itself.
  • What material is the Topper Screen made of?
    What should I do before installing the Topper Screen?
    What is the recommended method for installing the screen?
Grid Topper Screen Installation Instructions – Rev B.
GRID TOPPER SCREEN
INSTALLATION INSTRUCTIONS
OPEN PLAN / BENCHING
GI0002
WARNING:
Acrylic screens scratch and scuff easily. After removing
protective lm, immediately and carefully install the screen.
DO NOT remove protective lm from acrylic screens, then stack
them in a pile or against each other. Experience shows this will
cause marring and scratching.
INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
Topper Screen GasketGrid Frame
2) ASSEMBLY: GRID TOPPER
FIGURE 1
FIGURE 2
Topper Screens are installed after the Grid workstations
are otherwise fully assembled.
Make sure the Top Cap is tightened and free of debris.
Insert the Topper Screen into the gasket and ensure
that it is centered.
Spray/wipe a slightly soapy water solution all along the Top
Cap slot. The surface should be damp, but without puddles.
Center the Topper Screen end to end on the Grid Frame and
carefully push down until the Screen is fully seated into the
top cap. The Topper Screen should be level and the gasket
should sit just below the surface of the top cap.
Specications subject to change without notice.
Rev 02.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331
/