EZ-FLO 10667 Installation guide
- Category
- Sanitary ware
- Type
- Installation guide
This manual is also suitable for
Single Control
Bathroom Faucet
Before You Begin
Check to make sure you have the following:
Silicone
Sealant
10667
10669
Tools and Supplies
You will need the following to install your new faucet:
Pipe
Tape
Adjustable
Wrench
With Pop-Up
1 Screw & Plug A66D806
2 Metal Handle A069984
3 Handle Trim Cap A103121
4 Adjusting Ring A104041
5 Ceramic Disc Cartridge A507169N
6 Aerator 1.2gpm A553058N
7 Cover Plate Assembly A66F324
8 Mounting Hardware A663221-H
9 50/50 Pop-Up Assembly A505219-P
Phillips
Screwdriver
This product is engineered to meet the
EPA WaterSense flow requirement. The
flow rate is governed by the aerator. If
replacement is ever required, be sure to
replace it with a WaterSense compliant
lavatory faucet aerator to retain the water
conserving faucets of this faucet.
Shut off main water supply before installation.
1 Shut off hot and cold
water supply to faucet or
turn off main water
supply.
2
Remove lock nut. Install faucet
through center hole.
3 Unscrew screws on lock
nut. Slide rubber washer and
metal washer onto shank.
Secure shank with lock nut.
5 After installing faucet,
remove aerator and turn on
water to remove any left over
debris. Reassemble aerator
and tighten.
Faucet Installation
4 Connect and tighten the
water supply line nuts by using
two adjustable wrenches (avoid
twisting or kinking).
2
2 Place a ring of silicone sealant
beneath the lip of the drain collar (3)
and place it in the opening of the sink.
Press down firmly to secure the drain
collar (3).
3 Tighten the rubber washer (4)
and lock nut (5) onto the drain
collar.
Pop-Up Drain Installation
1 Remove the rubber washer (4) and
lock nut (5) from the drain assembly.
4 Connect tail piece on pop-up
drain to waste outlet (not included).
Check all drain connections and P
trap for leaks.
2
1
5
3
Lock nut
Cartridge
Drain collar
Stopper
Rubber washer
4
4.
5.
Keep this manual for ordering replacement parts.
Replacement Parts
1 Screw & Plug A66D806
2 Metal Handle A069984
3 Handle Trim Cap A103121
4 Adjusting Ring A104041
5 Ceramic Disc Cartridge A507169N
6 Aerator 1.2gpm A553058N
7 Cover Plate Assembly A66F324
8 Mounting Hardware A663221-H
9 50/50 Pop-Up Assembly A505219-P
Troubleshooting Guide
Minor problems often can be fixed without a plumber. Before doing any work on the faucet, shut off water supply and
close stopper or drain to avoid losing small parts.
noituloSesuaCmelborP
.
Leak from under handle Damaged cartridge Remove handle. Replace cartridge.
Uneven water spray Clogged aerator Remove aerator. Clean or replace aerator if necessary.
Leak from around aerator Bad aerator seal Remove aerator. Check to see that seal is flat and undamaged.
Replace aerator if necessary.
Water drains slowly or not at all Clogged drain Remove stopper. Remove visible debris.
If still clogged, remove and clean trap. Reassemble.
8.
7.
1.
3.
4.
5.
6.
9.
2.
-
1
-
2
-
3
-
4
EZ-FLO 10667 Installation guide
- Category
- Sanitary ware
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI