Anybus AB7552 Installation guide

Anybus
Brand
Anybus
Model
AB7552
Type
Installation guide
Anybus X-gateway - AS-Interface Master Interface Network Installation Guide
www.anybus.comSP1764, rev. 2.10, Dec 2016
Accessories Checklist
The following items are required for installation:
• USB cable (included)
• Null modem cable (not included)
• AS-Interface cables (not included)
Installation and Startup Summary
(Some steps are optional depending on your actual setup)
1. Connect the gateway to the AS-Interface network
2. Connect a PC to the gateway via USB (optional)
3. Connect a PC to the Master Confi g Connector using a
null modem cable (optional)
4. Power up and (if required) confi gure the gateway
Confi guration Button
The Confi guration Button has two functions:
• Mode Change – push and hold < 2 seconds
Toggles between Confi guration Mode and Protected Mode.
• Initiate Auto Confi guration – push and hold > 5 seconds
Uploads the current network confi guration and saves it as the
pre-set confi guration.
This function is only available in Confi guration Mode
The Confi guration Button will only function if bus power is present.
LED Indicators
LED Indication Meaning
GW Status See Gateway Installation Sheet
RUN Green Running
Red Idle
NS
Green Online, no connections
Green (1 Hz) Online according to confi guration
Red Offl ine
MS
Green Confi guration Mode
Green (8 Hz) Auto Confi guration in progress
Green (1 Hz) Protected Mode
Red Power fail bus
AUP
Green (8 Hz) Auto programming possible
Green (1 Hz) Slave address 0 exists
Red Periphery error
Red (8 Hz) Periphery error
Auto programming possible
Red (1 Hz) Periphery error
Slave with address 0 exists
Product Overview
The AS-Interface Master interface can only be mounted in the top slot
of the Anybus X-gateway.
Top view
AS-Interface
Connectors (X1.2)
Configuration Button
Master Config Connector
(X1.1) Power Connector (X3)
Front view
GW Status
RUN
NS
MS
AUP
USB Connector (X4)
Status LED:s
Technical Support
Technical support, documentation and software downloads are
available at www.anybus.com.
Technical questions regarding the AS-Interface fi eldbus system should
be addressed to www.as-interface.net.
Master Confi g Connector (RS232)
Pin Signal
15
96
1 (not used)
2 RxD
3 TxD
4 (not used)
5 Ground
6, 7, 8, 9 (not used)
Housing Shield
AS-Interface Connectors
Pin Signal
1 AS-Interface +
2 AS-Interface -
1122
  • Page 1 1

Anybus AB7552 Installation guide

Anybus
Brand
Anybus
Model
AB7552
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents