Matrox Monarch HD Quick start guide

Brand: Matrox

Model: Monarch HD

Type: Quick start guide

Matrox Monarch HD is a compact, portable device that allows you to capture and output HDMI video and audio signals. With support for up to 1080p60 resolution and a variety of video formats, Monarch HD is perfect for live streaming, recording gameplay, creating video tutorials, and more.

Rack mounting Matrox Monarch units

Hardware required

• One (1) mounting shelf (19 in. / 48.26 cm).

• Six (6) angled brackets for mounting three Monarch HD units, or two Monarch HDX units.

• Four (4) #10-32 × 3/4 in. Phillips pan head screws.

• Four (4) #12-24 × 3/4 in. Phillips pan head screws.

• Twenty-two (22) M3 4mm flat head screws.

Mounting guidelines

To prevent damage to your Matrox hardware, read the following guidelines before mounting:

• (Mounting shelf only) To install your mounting shelf, fasten it to the rack as per your rack’s instructions. The

pan head screws provided are compatible with most rack mounts.

• (Mounting shelf only) The mounting shelf has existing holes for your Monarch unit that allow the shelf to be

mounted facing forward or backward.

• Use a hand screwdriver to carefully tighten each screw. Do not over-tighten the screws.

• Don’t stack anything directly over the unit.

• Make sure the cables connected to your unit are properly secured and that no tension is applied.

• Make sure the ambient temperature doesn’t exceed the maximum recommended temperatures. For more

information, see the Specifications in your Monarch device's user guide.

Once the Monarch unit is mounted, you can connect your cables to the unit.

Mounting the Monarch unit on the mounting shelf

1 Use the M3 4mm flat head screws to secure two angled brackets to your Monarch (one on each side).

Each Monarch has two (2) mounting holes on each side, and each angled bracket has two screw holes (upper

and lower). For Monarch HDX, secure the unit using the angled bracket’s lower screw holes. For Monarch

HD, secure the unit using the upper screw holes.

2 Use the M3 4mm flat head screws to secure the Monarch to the mounting shelf via the angled brackets.

For Monarch HD, use the outer M / M holes. For Monarch HDX, use the AUX holes. You need one screw to

secure each bracket to the mounting shelf.

3 Secure the mounting shelf to your rack as per your rack’s instructions. The screws provided are compatible

with most rack mounts.

See the next page for an illustration of the proper placement of Monarch HD and HDX units on a mounting shelf.

Matrox is a registered trademark and Monarch is a trademark of Matrox Electronic Systems Ltd.

Monarch HD and Monarch HDX mounting

A = AVIO

M = MAEVEX

AUX = AUXILLARY

M / M = MAEVEX / MONARCH

P/N: F2920-02 REV B

M / M M / M

M / M

AUXAUX

19.00" / 48.26 cm

0.85" / 2.16 cm

17.30" / 43.94 cm

5.64" /

14.33 cm

M / M

AUX

M / M

AUX

MONARCH HD

Use the outer “M / M” holes

MONARCH HDX

Use the “AUX” holes

NOTE: Secure the angled

brackets to Monarch before

attaching Monarch to the

mounting shelf. Use lower screw

holes for Monarch HDX, upper

screw holes for Monarch HD.

MONARCH HD

MONARCH HDX

Matrox Monarch HD Quick start guide

Matrox Monarch HD Quick start guide

Matrox Monarch HD Quick start guide

Related papers

Other documents