American Standard ACTICLEAN 7381737-400.0070A Assembly

Brand: American Standard

Model: ACTICLEAN 7381737-400.0070A

Type: Assembly

ACTICLEAN

™

---------------------------------------------------------------- 1 ----------------------------------------------------------------

Product names listed herein are trademarks of AS America Inc. 7302225-100 (06/16)

FLAPPER ASSEMBLY WITH TEETER BAR

P/N: 7381737-400.0070A

•

Flapper assembly including adjustable teeter

bar with clevis & hair pins

TO REMOVE FLAPPER ASSEMBLY:

•

Turn off water supply; flush toilet (remove all

water from the tank)

•

Remove electronic tank top unit by lifting lid

and turning quarter turn screws to the Unlock

position and lifting upwards (see FIGURE 1)

•

Remove hair pin and clevis pin from the RED

trip lever arm (see FIGURE 2); this frees the

yoke from the red arm

•

Remove hair pin and clevis pin from the

BLACK trip lever arm (see FIGURE 2); this

frees the bead chain from the black arm

•

Place fingers underneath hinge and pull up

to release all 4 hinges (see FIGURE 3)

•

Remove original flapper assembly from tank

TO RE-INSTALL:

•

Align the flappers to the flush valve body and

push all four hinges into place (NOTE: the

bead chain should face the front of the tank)

•

Insert the RED trip lever arm into the yoke

(see FIGURE 2)

•

Push the clevis pin through the arm (see

FIGURE 2); make sure the head of the pin is

facing the front of the tank

•

Insert the hair pin (see FIGURE 2)

•

Attach the BLACK trip lever arm to the bead

chain coupler (see FIGURE 2)

•

Push the clevis pin through the arm (see

FIGURE 2); make sure the head of the pin is

facing the front of the tank

•

Insert the hair pin (see FIGURE 2)

FIGURE 1

FIGURE 2

FIGURE 3

ACTICLEAN

™

---------------------------------------------------------------- 2 ----------------------------------------------------------------

Product names listed herein are trademarks of AS America Inc. 7302225-100 (06/16)

FLAPPER ASSEMBLY WITH TEETER BAR

P/N: 7381737-400.0070A

COMPLETE BY ADJUSTING THE SETTINGS:

•

Depress trip lever handle all the way (A).

•

Adjust screw on the teeter bar (B) so rear frame (C) touches the frame stop (D).

•

Return trip lever handle (A) to rest position.

•

Make sure hook (E) is fully engaged under tab on valve body (F), if not, slightly adjust screw to

make sure hook is engaged.

•

Turn water supply on; adjust water level to specified dimension on tank liner sticker and flush

5 times to prime.

American Standard ACTICLEAN 7381737-400.0070A Assembly

American Standard ACTICLEAN 7381737-400.0070A Assembly

American Standard ACTICLEAN 7381737-400.0070A Assembly

Related papers

Other documents