FMI GA6054 User manual

Brand: FMI

Model: GA6054

Type: User manual

INTERNATIONAL

INSTALLATION INSTRUCTIONS FOR LOGMATE

™

FIREBOX

POLISHED BRASS HOOD ACCESSORY

Model GA6054: Fits FBST and FBPS Series

NOTE:

Read this entire instruction sheet before installing the fireplace hood. If

the hood is damaged, contact the dealer where you purchased this accessory or

DESA International at 1-800-972-7879 for referral information.

NOTICE:

Before replacing an existing hood on your LogMate

Firebox,

be sure the gas log heater is turned off and the hood has had time to

cool. The hood becomes very hot when the firebox is in use.

REMOVING EXISTING FIREBOX HOOD:

1. Remove the existing hood from your

LogMate Firebox by using a Phillips

Head screwdriver to remove the seven

screws securing the hood to the

firebox (

see Figure 1

). Save the

screws.

INSTALLING FIREBOX HOOD

1. Remove the protective wax paper from

the brass hood.

2. Mount the brass hood to your firebox

by aligning the holes in the hood with

the holes in the top of the firebox

opening. Hold the hood in place. Use

the Phillips Head screws to secure the

hood to the firebox (

see Figure 1

Hood

WARNING

The GA6054 hood may only be used on LogMate

firebox models FBST and

FBPS. This hood may not be used on any other firebox.

PO Box 90004

Bowling Green, KY 42102-9004

Technical Service Department

1-800-337-2564

Figure 1 - Screw and Hood Placement

105209-01

Rev. A

10/98

Firebox Top

Front

Panel

105209 01

NOT A UPC

FMI GA6054 User manual

FMI GA6054 User manual

Related papers

Other documents