INTERNATIONAL
INSTALLATION INSTRUCTIONS FOR
POLISHED BRASS HOOD ACCESSORY
Model GA6054: Fits FBST, FGPN, and FBPS Series
NOTE:
Read this entire instruction sheet before installing the fireplace hood. If
the hood is damaged, contact the dealer where you purchased this accessory or
DESA International at 1-800-972-7879 for referral information.
NOTICE:
Before replacing an existing hood on your firebox, be sure
the gas log heater is turned off and the hood has had time to cool. The
hood becomes very hot when the firebox is in use.
REMOVING EXISTING FIREBOX HOOD:
1. Remove the existing hood from your
LogMate Firebox by using a Phillips
Head screwdriver to remove the seven
screws securing the hood to the
firebox (
see Figure 1
). Save the
screws.
INSTALLING FIREBOX HOOD
1. Remove the protective wax paper from
the brass hood.
2. Mount the brass hood to your firebox
by aligning the holes in the hood with
the holes in the top of the firebox
opening. Hold the hood in place. Use
the Phillips Head screws to secure the
hood to the firebox (
see Figure 1
).
Hood
WARNING
The GA6054 hood may only be used on firebox models FBST and FBPS. This
hood may not be used on any other firebox.
PO Box 90004
Bowling Green, KY 42102-9004
Technical Service Department
1-800-337-2564
www.desatech.com
Figure 1 - Screw and Hood Placement
107120-01
Rev. A
02/00
Firebox Top
Front
Panel
107120 01
NOT A UPC
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Empire VFP36PB2EL-2 Owner's manual
-
White Mountain Hearth VFP36PB2EF-3 Owner's manual
-
-
Vanguard Managed Solutions NLFB32NC User manual
-
Desa Tech FB32NC User manual
-
-
Empire VFD36FB2DL-2 Owner's manual
-
-
-
Desa VFB36NC1 Owner's manual
