2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. TRUE FINE
  6. TD130012OT
TD130012OT

TRUE FINE TD130012OT Installation guide

  • Hello! I've reviewed the instruction manual for the Outdoor Wall Sconce. This document provides detailed steps for assembling and installing the light fixture, from turning off the power to mounting the fixture and installing the bulb. I am here to answer your questions about the installation process, safety information, compatible tools, and other details from this manual.
  • What should I do before beginning the installation?
    What type of bulb should I use?
    What are the required tools for assembly?
Instruction Manual
Outdoor Wall Sconce
Customer Service: [email protected]
PACKAGE CONTENTS
A
DESCRIPTION QUANTITY
AFixture 1
PART
Mounting plate
(Not actual size)
B
AA B
BB B B
CC DD
HARDWARE CONTENTS(shown actual size)
SAFETY INFORMATION
WARNING
PREPARATION
Long
monting
screw
x 2
Long
monting
screw
x 2 x 1
x 3
Wire nut
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
• TURN OFF ELECTRICITY at main fuse box (or circuit breaker box) before
beginning installation by removing fuse (or switching off circuit breaker).
• MINIMUM 90°C SUPPLY CONDUCTORS.
Estimated Assembly Times: 25 minnutes
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or
damaged, do not attempt to assemble the product.
Tools Required for Assembly (not included): Flathead screwdriver , Phillips screwdriver,
Pliers, Electrical tape, Wire cutters, Safety glasses.
Helpful Tools (not included): Wire strippers, Step ladder.
Print in china
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
1. Attach the mounting plate (DD) to the
outlet box (not included) with the long
mounting screws (CC).
6. Install light bulb (not included). Use one
E26 bulb.
1
Hardware Used
Long mounting screw
Mounting plate
x
2
x
1
3
CC
DD
BB
2. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers
(not included), black to black (power) and
white to white (neutral). Attach copper
wire to ground wire. Helpful hint:
If necessary, attach copper ground wire
to grounded outlet box.
2
3
BB
3. Attach wire nuts (BB).Tape wire nuts (BB)
and wires together.
Print in china
Hardware Used
x
Wire nut
6
DD
CC
5. Align the 2 screws(AA) through the holes
of the back plate, and fix them with screw
nuts
Hardware Used
5
AA
DD
A
DD
AA
Long mounting screw
Mounting plate
x 2
x 1
4. Screw out the screws in the cover, take out
the pearl cotton on the lampshade, then screw
the screws back.
4
/