2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. ZEGOLAER
  6. 41180851
41180851

ZEGOLAER 41180851 User manual

  • Hello! I've reviewed the instruction manual for the Wall Sconce. This document outlines the necessary steps for safely assembling and installing the outdoor light fixture, including how to attach the crossbar, connect wires, and secure the shade. I'm here to help answer any questions you have about the installation process or the components involved.
  • What should I do before beginning installation?
    What is the minimum temperature rating for supply conductors?
    What tools are required for assembly?
Instruction Manual
Outdoor Wall Sconce
PACKAGE CONTENTS
A
B
C
DESCRIPTION QUANTITY
AFixture 2
B
Socket ring (preassembled to Fixture (A))
2
C
Shade
2
PART
Crossbar
(Not actual size)
B
AA B
BB B B
CC DD
HARDWARE CONTENTS(shown actual size)
SAFETY INFORMATION
WARNING
PREPARATION
Short
monting
screw
x 4
Long
monting
screw
x 4 x 2
x 6
Wire nut
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
• TURN OFF ELECTRICITY at main fuse box (or circuit breaker box) before
beginning installation by removing fuse (or switching off circuit breaker).
• MINIMUM 90°C SUPPLY CONDUCTORS.
Estimated Assembly Times: 25 minnutes
Before beginning assembly of product, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or
damaged, do not attempt to assemble the product.
Tools Required for Assembly (not included): Flathead screwdriver , Phillips screwdriver,
Pliers, Electrical tape, Wire cutters, Safety glasses.
Helpful Tools (not included): Wire strippers, Step ladder.
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
1. 4.
5.
Attach the crossbar (DD) to the outlet box
(not included) with the long mounting
screws (CC).
Place fixeture (A) onto the crossbar (DD).
Secure with short mounting screws (AA).
Remove socket ring (C). Install shade (B)
over socket of fixture (A), then secure with
socket ring (C).
6. Install light bulb (not included). Use one
standard-base bulb or one standard-base
CFL bulb.
1
DD
CC
Hardware Used
Hardware Used
Long mounting screw
Crossbar
x 2
x
4
1
3
CC
DD
AA
DD
BB
2. Strip 3/4 in. of insulation from wire ends.
Twist stripped ends together with pliers
(not included), black to black (power) and
white to white (neutral). Attach copper
wire to ground wire. Helpful hint:
If necessary, attach copper ground wire
to grounded outlet box.
25
3
BB
3. Attach wire nuts (BB).Tape wire nuts (BB)
and wires together.
Hardware Used
x
Wire nut
Short mounting screw
Crossbar
x 2
x 1
A
B
6
or
C
DD
AA
/