2. LED WORLD
  3. SF10BB-2G
SF10BB-2G

LED WORLD SF10BB-2G Operating instructions

  • Hello! I've reviewed the instructions for the LED World Strip Connector SF10BB-2G. This document provides guidance on how to properly connect 10mm wide LED flex strips, emphasizing the importance of correct polarity and alignment of the connector. It specifies that it is for indoor use with a Class 2 power supply and type A LED flex strips. I'm here to help with your questions about this product.
  • What is the maximum current this connector can handle?
    What voltage is this connector compatible with?
    What type of LED strips can be used with this connector?
    Can I use any power supply with this connector?
Clear Dice Strip to Strip Connector SF10BB-2G
STEP 1
Clear Dice Connector
STEP 2
10mm wide LED strip
Hand tight but do not over tight
to damage PCB
Make sure that contact points are
right above the LED strip connector pads
+
To +
-
-
+
+ To +
-
CORRECT
x x
x x
x x
x x
10mm wide LED strip
+
-
+
-
WRONG
Unscrew terminal screws
1-800-387-4081
ledworldlighting.com ledworld.ca |
ATTENTION: Utiliser seulement avec la classe 2 bloc d’alimentation.
CAUTION: Max 3 Amps 12/24VDC (low voltage). Use only with Class 2 power supply. Indoor dry location use.
For use only with LED World’s type A (IP20) 12VDC and 24VDC 10mm wide LED Flex Strips. Not to be used with Type B or C (Strips that
have covers or coatings).
Important Note: Check the Polarity and make sure that connector contact points are directly over (and centered) the LED Flex
Strip connector pads. Do not connect LED strips at soldered contact points.
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 - 07/13/2023
Copyright @2023 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions.
Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
/