2. Columbia Lighting
  3. Surface Mount Kit

Columbia Lighting Surface Mount Kit Assembly Instruction

  • Hello, I've reviewed the Panel Surface Mount Kit (PSMK) instructions. This document details the installation process, highlighting key steps such as assembling the frame, mounting it to the ceiling, and inserting the panel. It also includes important safety warnings. I'm ready to answer your questions about the product and its installation.
  • What should I do before starting the installation?
    What to do if control devices are used with this luminaire?
    Who should install this product?
    What to do after installing, handling, cleaning, or otherwise touching this product?
Panel Surface Mount Kit (PSMK) Instructions
currentlighting.com/columbialighting
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 1
Rev 12/20/22
Panel Surface Mount Kit_inst
NOTE: Components shown in images are
representative only and may vary based
on the conguration ordered.
ACCESSORY PARTS
STEP 1
Assemble the four frames with screw A to a whole square.
INSTALLATION METHOD: SURFACE MOUNTING
Expansion bolts
2.4
"
Screw B(KA4X25)
Screw A(KA3X10)
Screw A
STEP 2
Fix the square frames to the ceiling with Screw B.
Expansion bolts
Screw B
STEP 3
Demount one frame.
STEP 4
Put the panel into the frame square.
STEP 5
Fix the last frame with screw A.
CAUTION
Read instructions carefully and turn electricity o at main circuit breaker panel before beginning installation.
WARNING
If any special control devices are used with this luminaire, follow the instructions carefully to assure full compliance with NEC requirements. If there are any
questions, contact a qualified electrical contractor.
WARNING
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and
the hazards involved.
WARNING
This product contains chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash hands after
installing, handling, cleaning, or otherwise touching this product.
/