2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. Garnet
  6. 709-BTP3
709-BTP3

Garnet 709-BTP3 User guide

  • I've reviewed the 709-BTP3 wiring diagram, which provides clear instructions for connecting pump switches, alarms, and LPG sensors. It details the power requirements, including fuse specifications, and the wiring for the pump LED and power input. I'm ready to answer any questions you have about this wiring diagram.
  • What is the maximum fuse rating?
    Is a relay required for the pump?
    What should be done if the alarm device exceeds 1 amp?
TM
Display
Double Stacked
Sender
Black
Sender
Grey
Sender
Fresh
Sender
Black Ground
Blue Sender
Ground
709-BTP3 Wiring Diagram
Red wire
+12V power
input to monitor
Does not sense LPG only. LPG
connects to the existing sensor.
Only relay the signal from the
sensor that`s already installed.
LPG Green
LPG Tank
Ground
Pump LED white wire
connects to the pump
side of all switches
709
SWITCH
EXISTING
BATHROOM
+12V
PUMP
LED
3-WAY SWITCH WIRING DIAGRAM
WHITE WIRE
PUMP
+12V
GROUND
Pump Switch
Connector
(see diagram
below)
W WARNING: All power circuits must be fused.
If a fuse is not provided with the system then it is the
installer’s responsibility to install a fuse with the
maximum rating of 7.5 amps. A relay is required if
more than 7.5 amps needed for the pump.
W WARNING: If the common alarm device
exceeds the maximum rating of 1 amp a relay
should be used.
Alarm Orange
Common
Alarm Output
/