Document 1900867 Installation Instructions for PREDATAIR Switch Panel Part #A700147 October 17, 2005
(NOT TO SCALE)
1/8”
DRILL ALL HOLES 7/64
3-5/32”
3-3/4”
1-25/32
5/32”
2-1/16
5/16”
5/16”
CUT OUT
PREDATAIR SWITCH PANEL INSTALLATION
Mount the panel in a protected location as it is not weatherproof. If you are dash-mounting the panel, make sure there is
sufficient space behind the location on the dash. Cut and drill the selected location using the dimensions in the following
diagram.
1. Install the relay and the 30 Amp fuse holder near the battery positive terminal or similar location for easy access.
For the following three connections, use 18 gauge wire.
2. Connect the orange wire from the switch panel to pin 86 on the relay using 18 gauge wire.
3. Connect the green wire from the switch panel to pin 85 on the relay to ground using 18 gauge wire.
4. Connect the red switch panel wire to a key switched 12 Volt source through a 1 Amp fuse using 18 gauge wire.
For the following two connections, use the recommended gauges. Keep power wires as short as possible.
Length of Wire Recommended Wire Gauge
Under 5 feet 12 Gauge
5 - 8 feet 10 Gauge
Over 8 feet 8 Gauge
5. Connect pin 87 of the relay to the red wire from the PREDATAIR.
6. Connect the free end of the supplied fuse holder to the battery positive terminal.
CURTIS
HOURS
Battery positive terminal
Fuse holder
86
Red
Relay
87a
30
87
Green
Green
85
Red
PREDATAIR
Orange
Key-switched 12 Volts
Red
1 Amp fuse
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Designtech 24923 User manual
-
Code Alarm 20038 Installation guide
-
Western 3-Port Isolation Module Harness Kit #69889 Parts List & Installation Instructions
-
Audiovox AX-900 User manual
-
-
SMC Networks PRO-9675FT4 User manual
-
-
-
-
Jensen Remote Starter JKRS3 User manual
