All American TQB4050 User manual

Brand: All American

Model: TQB4050

Type: User manual

The All American TQB4050 is a versatile pressure canner capable of preserving food through high-pressure steam canning. It features a large 21-quart capacity, allowing you to process a significant amount of food in one batch. The built-in pressure regulator and gauge ensure accurate pressure monitoring and control throughout the canning process. Additionally, the canner's sturdy construction and durable materials make it a reliable choice for home canning enthusiasts.

Pressure Reducing Valve

Installation

Instructions:

Control Panel

Pressure Reducing Valve

1. Requires air hose with 5mm inner diameter & 8mm outer diameter.

2. Requires air compressor with minimum 1.5kw, 50L hold tank, and 0.7M pa.

1. Pull pressure adjusting knob and rotate to adjust press pressure.

2. Push the drain valve at the bottom to release water from the air filter.

Press SET button one time to start adjusting the temperature. Press it again to adjust the time. Press it for the

third time to exit the setting interface.

Press and hold SET button to enter the parameter setting interface. Press and hold SET button again or power

off the machine to exit parameter setting interface.

Press this key to increase the corresponding paramater value after the machine enters the parameter setting

interface. Press and hold this key to start self-tuning (°C or °F symbol on the panel will begin blinking). Once the

machine begins self-tuning, do not unplug or press any key until self-tuning has finished (°C or °F symbol stops

blinking).

NOTE: Before applying self-tuning, set temperature to normal working temperature and let the heat plate cool down

to room temperature. Implement self-tuning after changing the heat plate, thermocouple wire, or control panel.

Press this key to decrease the corresponding parameter value after the machine enters the parameter setting

interface.

Emergency Stop Button

Auto/Semi-Auto Button

Press Button

(Both Sides)

Power Switch

Pedal Switch

Proxima Auto Dual Heat Press User Manual

Instructions

1. Auto Mode: Press foot pedal switch and the heat plate will move and press automatically.

Press Auto/Manual switch button to change operating modes.

2. Manual Mode: Press foot pedal switch, and the heat pate will move to the other work station.

Press both “Press Buttons” at the same time to press.

Plate Size

(in)

110V 1.8kw 260.15 308.65

42.5(L)x28.7(W)x23.2(H)

Voltage Power Dimensions (in) Shipping

Weight (lbs)

Actual

Weight (lbs)

Specifications

15.75

x19.69

All American TQB4050 User manual

All American TQB4050 User manual

All American TQB4050 User manual

Other documents